Senao Networks PCE4302AN Users Manual

User’s Manual

Model : PCE4302AN

1. Introduction

PCE4302AN

2.4 / 5 GHz

802.11a/b/g/n/ac

867Mbps

The PCE4302AN is adapting the next
generation 2-Stream Wi-Fi technology,

802.11ac. It provides the great improvement
in the performance compared with 802.11n
and achieves wireless performance of up to
867Mbps.

PCE4302AN is a dual band PCIe module to
support both 2.4Ghz and 5Ghz bands.

2. Feature

PCE4302AN

3. Hardware Installation

PCE4302AN

 802.11a/b/g/n/ac dual band operation in the 2.4GHz and 5GHz frequency

bands.

 Support WPA, TKIP, AES and WAPI hardware-based IEEE 802.11i encryption

engine

3-1. Installation Overview

PCE4302AN wireless module is design for Access Point, Router, IP Cam series and
Network products.

3.2 Safety Recommendations

The safety guidelines are as follows:

 Keep the board area clear and dust-free before, during, and after installation.
 Keep tools away from walk area where you and others could fall over them.
 Do not wear lose clothing or jewelry, such as earrings, bracelets hat could get

caught in the board

 Wear safety glasses if you are working under any conditions that might be

hazardous to your eyes.

 Do not perform any action that creates a potential hazard to people or makes the

equipment unsafe.

 Never attempt to lift an object that is too heavy for one person to handle.

3.3 Maintaining Safety with Electricity

Warning: Before working on a board or working near power supplies, unplug the
power cord on AC units; on DC unit, disconnect the power at the circuit breaker.

Follow these guidelines when working on equipment powered by electricity:

- Do not work alone if potentially hazardous conditions exist anywhere in your

work space.

- Never assume that power is disconnected from a circuit; always check the circuit.

- Extension cables, frayed power cords, and missing safety grounds. If an electrical

accident occurs, proceed as follows:

- Use caution; do not become a victim yourself

- Disconnect power from the system

- If possible, send another person to get medical aid. Otherwise, access the

condition of the victim and then call for help.

- Determine if the person needs rescue breathing or external cardiac compressions;

then take appropriate action.

3.4 Installing

- Remove the module from its protective packaging

- Avoiding Electrostatic Discharge

- Before your install the module, ground yourself by touching a piece of metal to

avoid electrostatic discharge (EDS).

You shall be able to take the following precautions to prevent damage to the module:

- Keep module in its antistatic-shielded bag until you are ready to install it.

- Handle the module by its edges.

- Ensure the connector is connected to above Model’s board tightly.