Seiko Instruments AB000005 User Manual

IFWL-001 User’s Manual

Overview

IFWL-001 is a Wireless LAN module for Seiko Instruments Printer.

This module provides functions for printing over Wireless LAN.

Install and set default value

1. Install IFWL-001 to Printer with 12pin FFC.

2. Turn the power ON and set default value from Web page or USB connection on FFC.

Web page: http://192.168.0.1

To set default value with USB connection, use commands by vendor request on USB.

For more detail information, please see specifications document.

How to use

1. #9100 port

Connect #9100 port and send printer command.

2. LPR port

Connect LPR port and send data with LPR protocol.

3. #26100 port

Connect #26100 port and send SVRP command.

Specifications

Standard: 802.11b/g/n, 802.11a/n

Input voltage: 3.0 to 3.6V

Maximum current: 500mA

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference, including interference that may cause

undesired operation.

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

Operations in 5150-5250 MHz band is for indoor use only.

Requirements to end product

This module must be integrated only by OEM integrators under the following

conditions.

(1) OEM integrator has to be aware not provide information to the users regarding

how to install or remove this module in the user’s manual of the end product which

integrate this module. Installation by end users is strictly prohibited.

(2) Antenna

OEM integrator shall use this module without any modifications including

antenna.

If module integrator uses a unique antenna, the FCC certification is required for

the end product.

OEM integrator must make sure that 20cm minimum separation is maintained

between users and the antenna.

(3) Co-location.

This module must not be co-located or operated in conjunction with any other

antenna or transmitter. The module integrator shall obtain FCC approval for the

end product, if the module is used for co-location operation.

(4) Markings

To satisfy FCC/IC exterior labeling requirements, the following text must be placed

on the exterior of the end product.

Contains Module FCC ID: C4ZAB000005, IC: 4445A-AB000005

Any similar wording that expresses the same meaning may be used.

(5) Caution to user for modification

The following caution is expressed on the user’s instruction manual.

The changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the device.

(6) Compliance statement to FCC

The following statement is expressed on the user’s instruction manual.

For Class A device;