Seiko Epson FBM224B User Manual

Bluetooth Interface Board User’s Manual

Features

The Bluetooth Interface board has the following features:

1) A built-in Bluetooth module

2) Bluetooth 2.1+EDR compatible

3) Power class: Class 2

4) External dimensions: 50 mm × 70 mm

Manufacturer: Seiko Epson Corporation

Model Name: M224B

Product Name: Bluetooth Interface board for printer

Integration to the end product

The Bluetooth Interface Board has to be installed and used in accordance with the technical

description/installation instructions provided by the manufacturer.

The system may only be implemented in the configuration that was authorized. Note that

any changes or modifications to this equipment not expressly approved by the manufacturer

could void the user’s authority to operate this equipment.

Regulatory Information

USA-Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy. If not installed and used in

accordance with the instructions, it may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

Bluetooth Interface Board User’s Manual

1

If this equipment does cause harmful interference to radio or television reception, which can

be determined by tuning the equipment off and on, the user is encouraged to try and correct

the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the distance between the equipment and the receiver.

-Connect the equipment to outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Labelling

The Bluetooth Interface board labelled as below.

FCC ID:BKMFBM224B

The proposed FCC ID label format is to be placed on the module. If FCC ID is not visible

when the module is installed into the system, “Contains FCC ID: BKMFBM224B” shall be

placed on the outside of final host system.

Caution: Exposure to Radio Frequency Radiation.

To comply with FCC RF exposure compliance requirements, a separation distance of at

least 20 cm must be maintained between the antenna of this device and all persons. This

device must not be co-located or operating in conjunction with any other antenna or

transmitter.

Bluetooth Interface Board User’s Manual

2