Seiko Epson AP005 Users manual
PS-100
0 14010 20 30 40 50 60 70 80 90 100 110 120 130 150 160 170 180 190 200 210
mm
Series
Notes on Using PS-100 Series and Components
Warning
Exercise according to your physical condition. Avoid sudden bursts of activity and overly vigorous exercise.
Stop exercising and consult your doctor if you feel unwell during exercise.
This product is a highly accurate sensor and able to measure your pulse rate; however, this is not a medical
device. If you have any concerns, consult our information center before using this product.
Quick Start Guide
©2014 Seiko Epson Corporation.
All rights reserved.
February 2014 printed in Japan.
Before Getting Started
Thank you very much for purchasing the PS-100 Series.
Read this guide carefully to use this product correctly. This guide describes how to set up and
configure the product. See the User's Guide for more detailed information. You can download the
guide from the following address.
http://www.epson.jp/support/
It is prohibited to copy part or all of this guide without permission.
Checking the Package Contents
Contact your store of purchase if there are any missing or damaged components.
This product
Charging cradle Quick Start Guide
(this document)
Warranty
Booklet
Do not look at this product constantly while walking or exercising. You may fall or have an accident. Be aware of
your surroundings.
This product is composed of precision equipment and electronic parts. Do not use or store this product in the
following environments. It may cause an electric shock or fire, or the product may malfunction or breakdown.
• Locations where the temperature and humidity vary widely • Near volatile substances
• Sooty or dusty places • Near a fire
• Near a strong magnetic field (for example, near a speaker)
Do not disassemble this product, and do not attempt to repair this product by yourself. It may cause an electric
shock or accident.
Do not leave this product within reach of young children.
Caution
Stop using the product immediately and consult your doctor if you have an allergic reaction or a rash while
wearing it.
Do not hold this product directly under a tap. Steam, soap, and hot spring agents may compromise the
waterproof feature or cause corrosion.
Notes on Using the Charging Cradle
Warning
Beware of the following when using the charging cradle, AC adaptor, and USB cable. Failure to note the
following may result in an electric shock, a fire, or a malfunction.
• Do not connect or disconnect the power cord with wet hands.
• Do not use a damaged AC adaptor or USB cable.
• Do not use them when they are emitting smoke or an unusual smell, or making noise.
• Do not use them when any foreign substances or liquid such as water enters them.
• Do not use the USB cable when any foreign substances such as dust is on the terminals.
• Do not use any adaptor other than the specified adaptor for charging.
The AC adaptor is optional. Purchase separately if required.
1. For Your Safety
Make sure you read the manuals (this document and the electronic manual "User's Guide") first
to use this product safely. The product may malfunction, or an accident may occur if it is handled
incorrectly.
• Keep the manuals handy to help you resolve any problems.
• When taking this product out of the country of purchase, check the laws and regulations in the
destination country before you travel.
• This product is not a medical device. Use this product as an indicator during physical exercise.
Meaning of Symbols
Manuals for this product use the following symbols to warn against dangerous operations and
handling to prevent personal injury and property damage. Understand the meaning of the
symbols before reading the explanation.
Warning
Caution
This symbol indicates things you must do.
This symbol indicates things you must not do.
Wristband adjustment hole finder
Ignoring this warning may cause serious personal injury or death.
Ignoring this warning may cause personal injury or property damage.
Notes on Taking Care of PS-100 Series
Do not attach the charging cradle when the product is wet. It may cause corrosion of the terminal
section or a malfunction. When the product is wet from water or sweat, wipe it with a damp cloth,
remove the moisture with a towel, and then dry naturally before attaching the charging cradle.
2. Wearing PS-100 Series
Wear the product closely around your wrist without slack. Tighten the wristband if your
pulse is not measured correctly while exercising.
Measure the circumference of your wrist, for example, using a string. Measure
1.
the circumference closely at the position indicated in the illustration without
touching the ulna bone.
Ulna
Place the string on the "Wristband adjustment hole nder" to nd the hole
2.
number.
Example: A piece of string that measures the circumference of your wrist.
S 1 S 3 S 5 S 7 S 9 L2 L4 L6 L8 L1 0
S 2 S 4 S 6 S 8 L1 L3 L5 L7 L9 L11
Align the end of the string to 0mm. Use hole number S8
Unfasten the buckle of the wristband as shown below.
3.
Insert the band fastener into the hole number you checked in step 2.
4.
Band fastener
Put your hand through the wristband and fasten the buckle. When wearing the
5.
product, make sure it does not touch the ulna bone. Move the band fastener to
a smaller hole number if the wristband is loose.
Ulna
Hole number
Insert the band fastener into
the wristband adjustment
hole
Detach the charging cradle from the product when charge is complete.
3.
Detach them by opening the part indicated with outwards and push the product
from the other side.
4. Initial Conguration
You need to perform initial conguration before using PS-100 Series for the rst time.
You can use a smartphone to perform the initial conguration.
Supported devices and operating systems
Check the following website.
http://
Perform initial conguration such as creating the account and pairing using a
smartphone.
Sensor
(reads your pulse on the back of your wrist)
3. Using PS-100 Series for the First Time
Charge the product as shown below when using it for the rst time. The product turns
on when charged. Make sure that charging is complete.
Attach the charging cradle to the product.
1.
Align the EPSON logos on the product and charging cradle and tilt the product as
A
shown.
Insert the protruding latch on the charging cradle into the hole on the side of the
B
product.
Protruding
Hole
latch
Search your smartphone's application store for Epson
1.
then install it.
Start Epson
2.
Make sure that the product is within one meter from the smartphone.
Follow the instructions in the Epson
3.
PULSENSE
View.
PULSENSE
View guide.
5. Contact Us
PULSENSE
View, and
Connect the USB connector.
2.
f Using a PC
Connect the charging cradle's USB cable to the USB port on the PC.
Note that some PCs may not be supported. Try connecting the charging cradle and
the PC directly without using a USB hub.
fUsing an AC adaptor
Connect the charging cradle's USB cable to the AC adaptor, and then connect
the AC adaptor to the power socket.
We recommend using the specified AC adaptor (XXXX optional.) Charging may not
be possible or the product may not operate if any other AC adaptor is used.
When connection is established, the LED light on the product turns on.
• The LED is orange while charging and blue
when charge is complete.
• Charging takes approximately TBD (1.5 to
2.5?) hours to complete; however, the
duration varies depending on the condition.
6. Service and Repair
OrangeBlue
Loading...