Seiko UB-R02 User Manual

UB-R02 User’s Manual

Printed in China 2004.01

Introduction

The UB-R02 is an interface board on which is installed an IEEE 802.11b Radio Frequency (RF) module for EPSON

This manual provides instructions, including a simple setup for operators of POS systems in which the UB-R02 is installed so that the operators can use the UB-R02 safely and correctly.

Key to Symbol

The symbol in this manual is identified by its level of importance, as defined below. Read the following carefully before handling the product.

Note:

Notes have important information and useful tips on the operation of your equipment.

Features and Functions

❏ 64/128-bit WEP ❏ Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for

OPOS)

❏ Transfer rate: up to 11 Mbps, depending on operating environment ❏ OPOS, APD support

Part Names

The following view shows the part names of the UB-R02.

TM printers.

410462701

Push button

Note: This photograph shows the TM-T88III printer with the UB-R02 installed.

Drawer kick-out connector

Power supply connector

DIP Switches

When using this interface board, the interface of the TM printer must be selected as “parallel” with the appropriate settings. Set the reset signal for pin 31 to “enable,” if you are using a TM printer that has this setting. Refer to the manual for each TM printer for details.

How to Set Up the UB-R02

Preparation

Printing a Status Sheet

Power on the printer. Wait for a few seconds. Then, hold down the push button on the interface card for more than 3 seconds. The printer prints the parameters for the UB-R02. You can check all setting values necessary (SSID, Network mode, IP address, Subnet mask, Gateway address) for the network connection.

Connection

Set the setting of the host PC and AP to match the network setting that you have confirmed with the status sheet.

You can check whether the connection to the printer has been correctly done by inputting the ping command through the command prompt.

Example: Ping 192.168.192.168

Note:

Although the example shows the address 192.168.192.168, use whatever IP address is reported on the status sheet.

Because the default IP addresses for all the wireless printers are the same, you should power on and configure only one printer at a time.

Resetting the UB-R02 to Factory Defaults

Hold down the push button on the interface card while turning on printer power and continue to hold it down for 5 seconds. This causes all internal settings to return to their factory defaults.

Setup

The TMNetWinConfig (version 2.0 or later) and the UB-R02 Technical Reference Guide are necessary for setup. Obtain them from the appropriate

web site below:

For customers from North America, go to the following web site: http://pos.epson.com/

For customers from other countries, go to the following web site: http://www.epson-pos.com/ Select the product name from the “Select any product” pull down menu.

+ 2 hidden pages