CAL. V33J
ANALOGUE QUARTZ
Hour hand
Day hand
Second hand
24-hour hand
Minute hand
ENGLISH
Date hand
CROWN
a b c
a: Normal position
b: First click
c: Second click
SCREW DOWN CROWN
[for models with screw down crown]
Unlocking the crown
1 Turn Crown counterclockwise until you no
longer feel the threads turning.
2 Crown can be pulled out.
Locking the crown
English
1 Push Crown back in to normal position.
2 Turn Crown clockwise while pressing it lightly
until tight.
2
TIME/CALENDAR SETTING
DAY AND TIME SETTING
Second hand
Day hand
1
➠
CROWN
1 Pull out to second click when
2
➠
4
Second hand is at the 12 o’clock
position.
2 Turn clockwise to advance Hour
3
and Minute hands until Day hand
is set to the desired day of the
week.
3 Turn to set the time.
4 Push back completely in
accordance with a time signal.
English
3
DATE SETTING
English
4
Date hand
1
➠
CROWN
2
1 Pull out to first click.
2 Turn clockwise to set Date hand
➠
3
to the desired date.
3 Push in.
NOTES ON OPERATING THE WATCH
DAY AND TIME SETTING
● To advance the day hand quickly, turn back the hour and minute hands 4 to 5 hours
beyond the point the day normally changes, and then advance them again until the day
hand is set to the next.
* The day hand will not move back by turning the crown counterclockwise.
● When adjusting the day hand, turn the crown slowly.
● When setting the hour hand, check that the 24-hour hand is correctly set.
● When setting the minute hand, advance it 4 to 5 minute ahead of the desired time and
then turn it back to the exact minute.
DATE SETTING
● Do not set the date between 9:00 p.m. and 1:00 a.m. Otherwise, it may not turn
properly.
● While setting the date hand, check that it moves properly in one-day increments.
● It is necessary to adjust the date at the end of February and 30-day months.
English
5
BATTERY CHANGE
Battery life : Approx. 3 years
3
Years
●
●
●
English
● Do not remove the battery from the watch.
● If it is necessary to take out the battery, keep it out of the reach of
● Never short-circuit, tamper with or heat the battery, and never expose
6
Battery : SEIKO SR916SW
As the battery is inserted at the factory to check the function and performance of
the watch, its actual life once in your possession may be less than the specified
period.
When the battery expires, be sure to replace it as soon as possible to prevent any
malfunction.
We recommend that you contact an AUTHORIZED PULSAR DEALER for battery
replacement.
WARNING
children. If a child swallows it, consult a doctor immediately.
it to fire. The battery may burst, become very hot or catch fire.
CAUTION
● The battery is not rechargeable. Never attempt to recharge it, as this
may cause battery leakage or damage to the battery.
English
7
TO PRESERVE THE QUALITY OF YOUR WATCH
WATER RESISTANCE
● Non-water resistant
• If the watch becomes wet, have it checked by an AUTHORIZED
PULSAR DEALER or SERVICE CENTER.
● Water resistant 5/10/15/20 bar
English
5
10/15/20
bar WR
• Before using in water, be sure the crown is pushed in completely.
• Do not operate the crown when the watch is wet or in water. If used
bar WR
in sea water, rinse the watch in fresh water and dry it completely.
• When taking a shower with the water resistant 5 bar watch, or
taking a bath with the water resistant 10, 15 or 20 bar watch, be
sure to observe the following:
* Do not operate the crown when the watch is wet with soapy water
or shampoo.
* If the watch is left in warm water, a slight time loss or gain may
be caused. This condition, however, will be corrected when the
watch returns to normal temperature.
8
* Pressure in bar is a test pressure and should not be considered as corresponding
to actual diving depth since swimming movement tends to increase the pressure
at a given depth. Care should also be taken on diving into water.
** We recommend that you wear a PULSAR Diver’s Watch for scuba diving.
TEMPERATURES
Your watch works with
+50°C
stable accuracy within a
temperature range of 5°
-5°C
C and 35° C (41° F and
Temperatures over 50° C (122° F)
may cause battery leakage or shorten
the battery life. Do not leave your
watch in very low temperatures below
–5° C (+23° F) for a long time since
the cold may cause a slight time loss
or gain.
However, the above conditions will
be corrected when the watch returns
to normal temperature.
95° F).
MAGNETISM
Your watch will be
adversely affected by
strong magnetism. Keep
it away from close contact
S
N
with magnetic objects.
CARE OF CASE AND BRACELET
To prevent possible
rusting of the case and
bracelet caused by dust,
moisture and perspiration,
wipe them periodically
with a soft dry cloth.
English
9
SHOCKS & VIBRATION
Light activities will not
affect your watch, but be
careful not to drop your
watch or hit it against hard
surfaces, as this may
cause damage.
CHEMICALS
Be careful not to expose
English
case, bracelet, etc. may become
discolored, deteriorated or damaged.
10
the watch to solvents,
mercury, cosmetic spray,
detergents, adhesives or
paints. Otherwise, the
PERIODIC CHECK
It is recommended that the
2 - 3
Years
DEALER or SERVICE CENTER to
ensure that the case, crown, gasket
and crystal seal remain intact.
PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
watch be checked once
every 2 to 3 years. Have
your watch checked by an
AUTHORIZED PULSAR
If your watch has a
protective film and/or a
sticker on the case back,
be sure to peel them off
before using your watch.
Loading...