SEIKAKU TECHNICAL GROUP UEM 8DR, UEM 8T Users manual

RR

UEM-8DR/8T SERIES

No.1, Lane 17, Sec. 2, Han Shi West Road, Taichung, 401 TAIWAN

Tel:[phone] Fax:[phone]

http://www.show-pa.com e-mail: [e-mail]

All rights reserved to SEIKAKU. All features and content might be changed

without prior notice. Any photocopy, translation, or reproduction of part of this

manual without written permission is forbidden. Copyright 2005 SEIKAKU GROUP

cc

NF03356-1.0

IMPORTANT!

Please read this manual carefully before operating

this unit for the first time.

All rights reserved to SHOW. All features and content might be changed
without prior notice. Any photocopy, translation, or reproduction of part of
this manual without written permission is forbidden.

SAFETY RELATED SYMBOLS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The symbol is used to indicate that some
hazardous live terminals are involved
within this apparatus, even under the
normal operating conditions.

The symbol is used in the service do­cumentation to indicate that specific
component shall be only replaced by
the component specified in that docu­mentation for safety reasons.

Protective grounding terminal.

Alternating current /voltage.

Hazardous live terminal .

ON: Denotes the apparatus turns on.

OFF: Denotes the apparatus turns off, be-

cause of using the single pole switch, be sure
to unplug the AC power to prevent any ele­ctric shock before you proceed your service.
WARNING: Describes precautions that
should be observed to prevent the danger
of injury or death to the user.

Disposing of this product should
not be placed in municipal waste
and should be separate collection.

CAUTION: Describes precautions that
should be observed to prevent danger of the
apparatus.

WARNING

Power Supply

Ensure the source voltage matches the
voltage of the power supply before turning
ON the apparatus.

Unplug this apparatus during lightning
storms or when unused for long periods
of time.

External Connection
The external wiring connected to the out­put hazardous live terminals requires
installation by an instructed person, or

the use of ready-made leads or cords.

Do not Remove any Cover

There are maybe some areas with high
voltages inside, to reduce the risk of electric
shock, do not remove any cover if the power
supply is connected.

The cover should be removed by the qual­ified personnel only.
No user serviceable parts inside.

Fuse
To prevent a fire, make sure to use fuses
with specified standard (current, voltage,
type). Do not use a different fuse or short
circuit the fuse holder.
Before replacing the fuse, turn OFF the
apparatus and disconnected the power
source.

Protective Grounding

Make sure to connect the protective
grounding to prevent any electric shock
before turning ON the apparatus.

Never cut off the internal or external pro­tective grounding wire or disconnect the
wiring of protective grounding terminal.

Operating Conditions

This apparatus shall not be exposed to
dripping or splashing and that no objects
filled with liquids, such as vases, shall be

placed on this apparatus.

To reduce the risk of fire or ele ctric shock,

do not expose this apparatus to rain or
moisture.
Do not use this apparatus near water.

Install in accordance with the manufactu rer's