SEIKAKU TECHNICAL GROUP UB 8P, UB 8H User Manual

RR

UB-81R/81DV
UB-8H/8P

SERIES

SEIKAKU TECHNICAL GROUP LIMITED

No.1, Lane 17, Sec. 2, Han Shi West Road, Taichung, 401 TAIWAN

Tel:[phone] Fax:[phone]

http://www.show-pa.com e-mail: [e-mail]

All rights reserved to SEIKAKU. All features and content might be changed

without prior notice. Any photocopy, translation, or reproduction of part of this

manual without written permission is forbidden. Copyright 2007 SEIKAKU GROUP

cc

NF02702-1.3

SPECIFICATION

Oscillation mode

MODEL

UB-8P

PLL UHF SYNTHESIZED

Carrier frequency band

Frequency response

Frequency stability

T.H.D

Modulation mode

RF output power

Dynamic :

Tone frequncy :

Curent drain :

Max.Deviation :

Battery:

Microphone Capsule

4 band choice

Dimensions :

UHF 740~769 MHZ

50Hz~15KHz( 3dB)

0.005%

0.8%

FM(F3E)

10mw

100dB

32.768KHz

150mA

35KHZ Deviation

"AA" type 2pcs (used for more than 6 hours)

Condenser or Dynamic Capsule

1. Condenser

2. Dynamic

3. Electric instrument

4. Ground

65(W) 111(L) 31(H)

IMPORTANT!

Please read this manual carefully before operating

this unit for the first time.

All rights reserved to SHOW. All features and content might be changed
without prior notice. Any photocopy, translation, or reproduction of part of
this manual without written permission is forbidden.

Weight :

0.105Kg(Approx.)

10

5. TECHNICAL SPECIFICATIONS

SPECIFICATION

Channel

Receiver type
Receiver type

Frequency band

Frequency response

Frequency stability

Modulation mode
T.H.D

Dynamic

Audio Output

Balance output

S/N Ratio

RF sensitivity

Power supply

Dimensions
Weight

SPECIFICATION

MODEL

MODEL

Oscillation mode

Carrier frequency band

Frequency response

Frequency stability

T.H.D

Modulation mode

RF output power

Dynamic

Tone frequency

Current drain

Max. Deviation

Battery

Microphone Capsule

Dimensions

Weight

Single-Channel

Non-Diversity
PLL UHF SYNTHESIZED

UHF 740~769MHz

50Hz~50KHz( 3dB)

0.005%

FM(F3E)

1%

100dB

unbalanced 6.3mm phone jack
280mv 15KHz deviation

280mV at 15KHz deviation

90dB

-100dbm/30db sinad

DC 12V/500mA(AC 120V
/230V 50/60Hz Adaptor)

130(W) 44(H) 201(L)

0.350Kg(Approx.) 0.365Kg(Approx.)

PLL UHF SYNTHESIZED

UHF 740~769 MHZ

50Hz~15KHz( 3dB)

FM (F3E)

10mw

32.768KHz

"AA" type 2pcs

Dynamic Capsule

220mm

0.16Kg(Approx.)

UB-81R

UB-8H

0.005%

0.8%

100dB

150mA

35KHZ Deviation

9

UB-81DV

Single-Channel

Diversity
PLL UHF SYNTHESIZED

UHF 740~769MHz

50Hz~50KHz( 3dB)

0.005%

FM(F3E)

1%

100dB

unbalanced 6.3mm phone jack
280mv 15KHz deviation

280mV at 15KHz deviation

90dB

-100dbm/30db sinad

DC 12V/500mA(AC 120V
/230V 50/60Hz Adaptor)

130(W) 44(H) 201(L)

SAFETY RELATED SYMBOLS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The symbol is used to indicate that some
hazardous live terminals are involved
within this apparatus, even under the
normal operating conditions.

The symbol is used in the service do­cumentation to indicate that specific
component shall be only replaced by
the component specified in that docu­mentation for safety reasons.

Protective grounding terminal.

Alternating current /voltage.

Hazardous live terminal .

ON: Denotes the apparatus turns on.

OFF: Denotes the apparatus turns off, be-

cause of using the single pole switch, be sure
to unplug the AC power to prevent any ele­ctric shock before you proceed your service.
WARNING: Describes precautions that
should be observed to prevent the danger
of injury or death to the user.

Disposing of this product should
not be placed in municipal waste
and should be separate collection.

CAUTION: Describes precautions that
should be observed to prevent danger of the
apparatus.

WARNING

Power Supply

Ensure the source voltage matches the
voltage of the power supply before turning
ON the apparatus.

Unplug this apparatus during lightning
storms or when unused for long periods
of time.

External Connection
The external wiring connected to the out­put hazardous live terminals requires

installation by an instructed person, or
the use of ready-made leads or cords.

Do not Remove any Cover

There are maybe some areas with high
voltages inside, to reduce the risk of electric
shock, do not remove any cover if the power
supply is connected.

The cover should be removed by the qual­ified personnel only.
No user serviceable parts inside.

Fuse

To prevent a fire, make sure to use fuses
with specified standard (current, voltage,
type). Do not use a different fuse or short
circuit the fuse holder.

Before replacing the fuse, turn OFF the
apparatus and disconnected the power
source.

Protective Grounding

Make sure to connect the protective

grounding to prevent any electric shock

before turning ON the apparatus.

Never cut off the internal or external pro­tective grounding wire or disconnect the
wiring of protective grounding terminal.

Operating Conditions

This apparatus shall not be exposed to
dripping or splashing and that no objects

filled with liquids, such as vases, shall be
placed on this apparatus.
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.

Do not use this apparatus near water.
Install in accordance with the manufacturer's