External Battery User Manual
www.segway.com
V1.0
1 Installing a Second Battery Pack
Follow thes e steps w hen installing a second ba ttery pack:
1. Remove th e three screws on th e stem, as shown.
Then remove the cover near the c harge port.
Warnin g: please use the screws provided with this produ ct only.
2. Insta ll the rail with the M4 (10mm) screws (3
pcs), prov ided with t his product . Please make
sure it is properly fixed.
3. Install the external battery on the rail and fix it with the M4 (20mm)
screws (2 pcs), provided with this product. After they are properly
installed, block the screw holes with the rubber stopper.
2 Charging
Chargin g step tip s
Charge p ort
Open the charge
port cover.
4. Verify that your KickScooter powe rs on and off.
Inser t the
charge p lug.
Close the charge
port cover when
finis hed.
WARNING
Do no t connect th e charger if the charge por t or charg e cable is wet .
Your KickScooter is fully charged when the LED o n the charger changes from red (cha rging) to green (trickle charge) .
Close the charge port cover when n ot charging.
3 Specifications
Item
External Battery
Nomin al Voltage
Max. Charging Volta ge
Charging Tempera ture 32–104° F (0-40°C)
Nomin al Capaci ty
Battery Management System
36 VDC
42 VDC
187 Wh
Over-hea ting, short c ircuit, over-curre nt and over-charge protection
Loading...