SEGI JR940 2WSS User Manual
User Manual
Remote FCC ID Number IC ID Number
2WNANO VA5JR940-2WSS 7087A-R940WSS
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions;
(1) This device may not cause harmful interference.
(2) This device may accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this device.
Statement : The term “IC”. before the radio certification number only signifies that Industry
Canada technical specifications were met.
CAUTION : The User that modifications to the unit may void the user’s authori-ty to operate
The unit
7RPDLQWDLQFRPSOLDQFHZLWK5)HQHUJ\H[SRVXUHJXLGHOLQHVWKHDQWHQQDXVHGIRUWKLVWUDQVPLWWHUPXVW
EHPDLQWDLQHGDVHSDUDWLRQGLVWDQFHRIDWOHDVWFPIURPWKHXVHUERG\ZKHQWUDQVPLWWLQJ
&RORFDWHGRURSHUDWHGLQFRQMXQFWLRQZLWKDQ\RWKHUDQWHQQDRUWUDQVPLWWHULVSURKLELWHG
Quick Reference
Remote Maintenance – Battery Replacement
The only regular maintenance this system requires is remote control battery replacement. No
programming is required when replacing the battery.
Two Way Remotes:
First, remove the small Phillips screw located on the back of the remote. Once the screw has been
removed, gently pull the remote apart taking care to not damage the circuit board. Your battery size
should be listed on the battery. IMPORTANT: Be sure to observe correct polarity when installing the
battery.
2
2 Way Remote Button Functions
Button(s) Duration Function LED Chirp(s)
0.5 second Locks doors and/or arms alarm. Once
3.5 seconds
0.5 second Unlocks doors and/or disarms alarm. Twice
0.5 second
Panic/vehicle locater (flashes vehicle’s
parking lights and sounds siren and horn).
Aux 1. Triggers the auxiliary 1 output
(most commonly used for rear defrost or
window roll-down).
Once
N/A
2.5 seconds
0.5 second
2.5 seconds
0.5 second
2.5 seconds
0.5 second
0.5 second
2.5 seconds
0.5 second
2.5 seconds
0.5 second
0.5 second
2.5 seconds
Trunk release. Triggers the trunk release
output and opens the vehicle’s trunk.
Aux 2. Triggers the auxiliary 2 output
(most commonly used for rear defrost or
window roll-down).
Activates the remote start. Repeat and
remote start will shut off. Will activate
Stop and Go Mode if held when vehicle is
running with the key.
Turns siren chirps on/off (Note: With the
siren chirps off, it will still sound in the
event the alarm is triggered).
Option programming menu 1 - Installers
Only.
Valet mode (see Valet Mode Section for
details)
Drive lock. Activates ignition controlled
door locks.
Option programming menu 2 - Installers
Only.
Activates passive arming (vehicle will
arm/lock 30 seconds after the vehicle is
disarmed)
Activates the 2nd Car function. Your
remote has the ability to control two
systems with the same remote. You must
have the same RF Kit in both of your
vehicles.
Activates timer start mode. Timer start
mode has multiple programmable
settings: duration settings, temperature
settings and self start settings.
Activates the built in Turbo Timer function.
Additional installation is required when
using this feature on automatic
transmission vehicle’s.
Car Check (updates vehicle status on
remote pager) / Secure Auxiliary
Twice
Once
Once On /
Twice Off
Once On /
Twice Off
Once
Once On /
Twice Off
Once On /
Twice Off
Once
Once On /
Twice Off
Once On /
Twice Off
Once On /
Twice Off
Once On /
Twice Off
Twice
3
Loading...