SEGI JR181FM907 User Manual
MR181
FCC ID : VA5JR181FM907
One-Way FM Remote
MR181
Remote:MR181
13
10.
-
11.
2 sec Shock Sensor – on/off
2 sec Programming Menu 1 –
Installer Only
2 sec Programming Menu 2 –
Installer Only
Note:
Note:
- meand pressing the button for 2 seconds.
( ) means simultaneously pressing the buttons
( ) – means simultaneously pressing the buttons for 2
seconds
Remote Learn Routine
The Compustar will allow up to three remotes to be
programmed to one vehicle. Please perform the
following procedure to add or reprogram additional
remotes.
Step 1: Activate Valet/Programming mode by
manually turning the ignition on and off five times
(between Acc and On) with car key within a 10
second period. The parking lights will flash once with
successful completion of this step.
Step 2: Within a 10 second period after cycling the
ignition for the 5th time, press button I ½ sec. The
car parking lights will flash once to confirm that the
transmitter has been programmed. Continue
programming the additional remotes. The parking
lights will flash two times when the programming
mode is expired.
Keyless Entry
You can lock or unlock the vehicle by pressing
Button for a ½ second.
Alarm Mode
You can arm or disarm alarm mode by pressing
Button for a ½ second.
Press Buttons for a ½ second to make your
car siren mute when arming or disarming your vehicle.
Keep in mind that your car siren will still activate for all
other modes (i.e. panic, alarm, shock sensor)
regardless of whether or not your car siren is in mute
mode. The car siren will be mute only when arming
or disarming your vehicle.
In alarm mode, the starter kill function (this maybe
an optional feature provided by your installer) is
activated. This feature disengages the starter
mechanism on your car that prevents you from
starting your car even with a manual key when your
vehicle’s alarm mode is activated.
Note: If you lose your remote after you have armed
the vehicle, use your key to open the vehicle. The
siren will go off. Turn on and off ignition 5 times with
your key to shut off the siren and turn the system into
valet mode. Cancel the valet mode with remote later.
See Valet mode.
Note: (Siren duration is 30 to 60 sec depending on the options set at the
time of initial installation.)
Dual Stage Shock Sensor
• Press Buttons for 2 seconds to
activate or deactivate the dual stage shock
sensor. The dual stage shock sensor will
activate 30 seconds after the CompuStar
alarm mode is armed.
Auto-Start Function
Press Button for 2 seconds to auto-start an
automatic transmission engine.
Remember that actual key in the ignition is required to
drive the car. In addition, the anti-grind circuit (this
maybe an optional feature provided by your installer)
prevents you from re-cranking the starter on a remotestarted vehicle. Press Button for 2 seconds in
order to turn off an auto-started car. For manual
transmission vehicles, please use reservation mode.
Refer to page 3.
The engine will run 15 or 25 minutes (25 or 40 min for
diesel) depending on preset options at the time of
installation, and then shut off. If your vehicle has a
problem starting with the remotestart, the CompuStar
User’s Guide Page 2 of 6
Loading...