Seeley Tudor Romeo Owners & Installation Manual

(English)(Tudor Romeo)

Tudor Romeo Gas Cooktop

OWNER’S & INSTALLATION MANUAL

THIS APPLIANCE MUST BE
INSTALLED AND SERVICED
BY AUTHORISED
PERSONNEL ONLY.

THIS APPLIANCE IS NOT
SUITABLE FOR
INSTALLATION IN MARINE
CRAFT, CARAVANS OR
MOBILE HOMES.

DO NOT: Operate this appliance

before reading these
instructions.

DO NOT: Store flammable
materials near this
appliance.

DO NOT: Spray aerosols in the
vicinity of this appliance
while it is operating.

DO NOT: Operate this appliance
with any parts removed.

DO NOT: Modify this appliance.

Before requesting a service call
please run through the simple
checks in the "Troubleshooting"
section of this manual.

If required, call Service on
1300 650 276.

For spare parts call 1300 367 437.

2

IF YOUR COOKTOP
STOPS WORKING

IMPORTANT SAFETY
INFORMATION

Large Boiling

Burner

Super Simmer

Burner

Wok Burner

3SEELEY INTERNATIONAL – OWNER’S & INSTALLATION MANUAL

Different burner options are available
for Tudor Romeo gas cooktops.
Cooktops are fitted with different
combinations of the following burners
depending on your model selection:

•

"SUPER SIMMER" dual-ring burners,

•

"LARGE BOILING" single-ring

burners,

•

"WOK" dual-ring burners.

Lighting & Adjusting the Burners
Electronic Ignition Models

Large Boiling Burner

1 Depress the knob for the required

burner to initiate the spark.

2 Turn the knob fully anti-clockwise to
“HI”.

3 Release the knob once the burner
lights.

4 Turn the knob to adjust to the
required heat setting.

Dual Ring Burners - Inner Ring Only

1 Depress the knob for the required

burner to initiate the spark.

2 Turn the knob fully anti-clockwise to
“HI”.

3 Release the knob once the burner
lights.

4 Turn the knob to adjust to the
required heat setting.

Dual Ring Burners - Inner AND Outer
Ring

1 Depress the knob for the required

burner to initiate the spark.

2 Turn the knob clockwise to “HI”.

3 Release the knob once both inner

and outer burners light.

4 Turn the knob to adjust to the
required heat setting.

Lighting & Adjusting the Burners
Manual Ignition Models

1 Place a hand-held ignition device

alonside the burner to be ignited
(outer burner if lighting both rings of a
dual burner.

2 Depress knob corresponding to the
required burner and turn to the
marked “HI” position.

3 Release the knob once the burner
lights.

4 Turn the knob to adjust to the
required heat setting.

Turning the Burners Off

1 Turn the knob corresponding to the

required burner to the marked “OFF”
position.

USER INSTRUCTIONS

4

USER INSTRUCTIONS cont.

Safe Operation

DO NOT place anything (eg, flame

tamer, simmer mat) between the pot
and the trivet as serious damage/glass
breakage may result.

DO NOT remove the trivet and enclose
any burner with a wok stand.

DO NOT use large pots or heavy
weights which could deform the
cooktop.

DO NOT allow the pot to protrude past
the edge of the cooktop. Ensure that the
pot is located centrally over the burner.

DO NOT place hot objects directly onto
the glass surface.