Seed SED-10R User Manual

Download

Page 1

Remote

USER GUIDE

for #SED-10R

Customer Support:

866-377-4771

support@goecolife.com

c--'

c-'

OFF

LINK

http://www.monomachines.com

Page 2

http://www.monomachines.com

Page 3

Table of Contents

Product Speciﬁcations & Diagram.........................2

Caution ...................................................................3

Technical Information...........................................4-5

Introduction .............................................................6

Set Up Link...............................................................7

Operation .............................................................8-9

Mounting Holster..................................................10

Frequetly Asked Questions (FAQs)................ 11-13

Limited Product &

nnected Equipment Warranty............. 14-16

http://www.monomachines.com

Page 4

Product Speciﬁcation

SEED

™

Remote & Holster

Mountable

Holster

Power ON/ LINK Indicator Light

Power ON

Button

Power OFF

Button

LINK to

Remote

Button

• Remote Range..............................65 ft/20 m

• Remote Frequency .........................433MHz

• Batteries (not included).............Size AAA (2)

• Dimensions (L x W x H)......4.8 x 1.8 x 0.6 in

.......................................121 x 45 x 15 mm

• FCC ID: YF3MC-SED10R01

http://www.monomachines.com

Page 5

CAUTION

• FOR INDOOR USE. DO NOT

USE THIS PRODUCT NEAR WET AREAS SUCH AS SINKS AND NEAR AQUARIUMS.

http://www.monomachines.com

Page 6

FCC Information

• FCC ID: YF3MC-SED10R01

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful

interference, and

2. This device must accept any

terference received, including interference that may cause undesired operation.

WARNING: DO NOT CHANGE OR MO

DIFY THE DEVICE. THIS COULD VOID THE USER’S AUTHORITY TO OPERATE THE DEVICE.

• This equipment has been tested and fo

und to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. however, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,

http://www.monomachines.com

Page 7

FCC Information (cont’d)

the user is encouraged to try to correct th

e interference by one or more of the following measures:

1. Reorient or relocate the receiving

antenna.

2. Increase the separation between the

uipment and receiver.

3. Connect the equipment into an

tlet on a circuit different from that

to which the receiver is connected.

4. Consult the dealer or an

experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, any changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices).

http://www.monomachines.com

Page 8

Introduction

Thank you for purchasing the SEED™ Remote. This device helps eliminate phantom power consumption by electrical devices which are powered OFF. PLEASE READ THROUGH THIS USER GUIDE CAREFULLY to ensure proper set up and operation of the SEED™ Remote.

PLANNING

• Make sure that the electrical de

vices you are planning to use with the SEED™ are NOT DEVICES WHICH REQUIRE CONTINUOUS POWER.

(i.e.

Refrigerators, Clocks, Telephones.)

• First determine which electrical de

vices drain the most power

while turned OFF. (i.e. Plasma

TVs, Game Consoles, VCR/DVD players, Computers, Laser Printers, Monitors, Audio Systems.)

• Locate an area for convenient ac

cess to mount the remote holster (such as near the entrance to a room or near the bed.)

http://www.monomachines.com

Page 9

Set Up Link

A. Press the LINK button on the

SEED™ device. The indicator light will ﬂash a blue light.

B. Then press the LINK button on

e remote. The indicator light will show a blue light for about a second. When both the ﬂashing blue light on the SEED™ device and the blue light on the remote turns off, the remote is now linked to the SEED™ device.

NOTE : It is possible to link the re

mote to 99 SEED™ devices. Inversely, an individual SEED™ device can be controlled by 4 SEED™ Remotes. Follow the same procedure to link another SEED™ device to the remote.

Link up to 99 SEED

™

The SEED™ can be

devices

controlled

by 4 SEED

™

Remotes

http://www.monomachines.com

Page 10

Operation

POWERING ON THE SEED™ DEVICE

Before powering on the electrical de

vices connected to the SEED™, you must POWER ON the SEED™. To POWER ON the SEED™ with the SEED™ Remote, press the ON button on the remote.

http://www.monomachines.com

Page 11

Operation

POWERING OFF THE SEED™ DEVICE

There is only one way to manually po

wer OFF a SEED™ device:

• Press the OFF button for 3 s

econds on the remote.

NOTE: The SEED™ device is de

signed to automatically power OFF 5 minutes after all connected electrical devices have been turned off. Once the SEED™ device is powered OFF, all power consumption is eliminated. THIS DOES NOT APPLY TO THE “ALWAYS ON” OUTLET.

http://www.monomachines.com

Page 12

Mounting the Holster

MOUNTING THE SEED REMOTE HOLSTER

On the back of the remote holster, ex

pose the cover of the adhesive

tape and attach vertically to either the wall or furniture. Place the remote holder in a location convenient for you to turn off your devices (i.e. near existing light switches, near entrances, or near the bed.)

http://www.monomachines.com

Page 13

Frequently Asked Questions (FAQs)

How does the SEED™ save energy?

Electrical devices and appliances left pl

ugged into outlets but turned OFF still draw electricity. This is known as “phantom load” or vampire energy consumption. Therefore, your electrical devices and appliances constantly draw and waste valuable energy from the moment you power them OFF till the moment you power them back ON. The SEED™ will passively shut off all power consumption* to the electrical devices plugged into it 5 minutes after the last device is turned OFF. *Does not apply to ALWAYS ON outlet.

The remote does not work.

As the battery nears the end of its us

eful life, the remote range may start to decrease. Remove the battery cover on the back of the remote and replace the two (2) AA batteries.

PLEASE DISPOSE OF THE USED BA

TTERIES RESPONSIBLY.

What is the maximum range of the re

mote?

Your remote has a range of up to 65

feet (20m). This range may vary depending on the construction of your home or ofﬁce. It operates by radio frequency so a direct “line of sight” is not required.

http://www.monomachines.com

Page 14

Frequently Asked Questions (FAQs)

Can I link an additional remote to the same SEED™?

Yes. You can link 4 SEED™ Remotes to a s

ingle SEED™.

Can I link my remote to more than one SE

ED™?

Yes. You can link your SEED™ remote to

up to 99 SEED™ devices. You can also link one or multiple remotes to one or multiple SEED™ devices.

Why is there is no OFF button on my SE

ED™?

The SEED™ operates passively so yo

u do not need to alter your regular behavior or relearn new habits. Just power off your electrical devices or appliances as you normally would and your SEED™ will automatically power OFF 5 minutes after all connected electrical devices or appliances have been powered OFF.

Why is there is an OFF button on my SEED™ remote?

In the event that you want to manually po

wer OFF the electrical devices or appliances connected to your SEED™, you can do so by holding the OFF button on your remote for 3-5 seconds. This is particularly convenient for remote ON/OFF operation for products that do not have a power ON switch (eg. holiday lights) or for products that have a hard ON/OFF switch (eg. lamp).

http://www.monomachines.com

Page 15

Frequently Asked Questions (FAQs)

What does “Certiﬁed CarbonFree®” mean?

Your SEED™ is a carbon neutral pr

oduct. It meets Carbonfund.org’s CarbonFree® Product Certiﬁcation protocol which requires third-party life cycle assessment of the product’s carbon footprint, and carbon reductions in support of third-party validated renewable energy and reforestation projects. To learn more, visit www.carbonfund.org/products.

Who is Carbonfund.org?

Carbonfund.org is a 501(c)(3) n

nproﬁt organization which supports renewable energy, energy efﬁciency and reforestation projects globally that reduce carbon dioxide emissions and the threat of climate change. For more information, visit: www.carbonfund. org.

Is the SEED™ RoHS Certiﬁed? What do

es that mean?

Yes, the SEED™ is RoHS certiﬁed. Ro

HS stands for Restriction of Hazardous Substances. It restricts the use of six hazardous materials (including Lead and Mercury) in the manufacture of various types of electrical and electronic equipment.

http://www.monomachines.com

Page 16

Limited Product Warranty

Intek America, Inc. (the “Manufacturer”) warrants to the original purchaser (the “Purchaser”) of the SEED™ Remote for period of one (1) year after the date of purchase, that the SEED™ Remote shall be free of defects in design, assembly, material, or workmanship for as long as the original Purchaser owns it, Manufacturer will repair or replace, or if repair or replacement is not feasible, will provide a refund of the purchase price of any defective SEED™ Remote free of charge.

THIS LIMITED WARRANTY IS VALID ONLY IN AC

CORDANCE WITH THE CONDITIONS SET

FORTH BELOW:

1. NORMAL WEAR AND TEAR ARE NO

T COVERED BY THIS WARRANTY.

2. THIS WARRANTY EXTENDS ONLY TO TH

E ORIGINAL PURCHASER AND IS NOT TRANSFERABLE. PROOF OF PURCHASE MUST BE DEMONSTRATED.

3. The Manufacturer reserves the ri

ght to review the damaged SEED™

Remote.

4. If requested by the Manufacturer, th

e Purchaser must ship, at its own expense, the SEED™ Remote to the Manufacturer for inspection. Any such equipment must remain available for inspection until the claim is ﬁnalized. Whenever claims are settled, the Manufacturer reserves the right to be subrogated under any existing insurance policies the claimant may have.

5. This Warranty shall become null an

d void if:

(a) The SEED™ Remote is not provided

to the Manufacturer or the designated equipment repair facility for inspection

http://www.monomachines.com

Page 17

Limited Product Warranty

(cont’d)

upon the Manufacturer’s request at the sole expense of the Purchaser.

(b) The Manufacturer determines that

the SEED™ Remote has been subject to accident, misuse, abuse, improper maintenance or repair.

scretion, that the damage resulted from an incident caused by an act of God other than lightning (e.g. ﬂood or earthquake), war, vandalism, theft, normal-use wear and tear, erosion, depletion, obsolescence, abuse, damage due to lowvoltage disturbances (i.e. brownouts or sags), non-authorized program, or system equipment modiﬁcation or alteration.

(d) The SEED™ Remote is not used indoors

ly and in dry areas.

6. THIS LIMITED WARRANTY IS THE ON

LY WRITTEN OR EXPRESS WARRANTY

GIVEN BY THE MANUFACTURER. ANY IMPLIED WARRANTIES ON THE PRODUCT (INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.

7. REPAIR OR REPLACEMENT OF THE PR

ODUCT IS THE EXCLUSIVE REMEDY OF THE PURCHASER UNDER THIS WARRANTY. MANUFACTURER SHALL NOT BE LIABLE FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING LOST DATA AND/OR LOST

http://www.monomachines.com

Page 18

Limited Product Warranty

(cont’d)

BUSINESS OR PROFITS) FOR BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY ON THIS PRODUCT EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.

8. THIS WARRANTY GIVES YOU SP

ECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

9. This warranty is valid only in the US

A, Canada, and Puerto Rico.

To ﬁle a claim against the Manufacturer, you mu

st contact INTEK America, Inc., at 18528 S. Dominguez Hills Drive, Rancho Dominguez, CA 90220, Attn: Customer Support, or call 866-377-

4771. All claims must be ﬁled within 15 days from the date of an Incident, if any, and must be accompanied by proof of purchase for the SEED™ Remote and must include the following information:

1. The SEED™ product model number

2. Where you purchased the SEED™ Remote an

d any damaged connected equipment.

3. When you purchased the SEED™ Remote an

d any damaged connected equipment.

http://www.monomachines.com

Page 19

http://www.monomachines.com

Page 20

Customer Support:

866-377-4771

support@goecolife.com

Rancho Dominguez, CA 90220.

http://www.monomachines.com

Seed SED-10R User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual