Security Tronix ST-PTZ-RC User Manual

v1.2 8/22/11

1

USER MANUAL

ST-PTZ-RC

Infrared Remote PTZ Controller

v1.2 8/22/11

2

PACKAGE CONTENTS

This package contains:

One ST-PTZ-RC handheld infrared remote controller
One PT Dome Controller
One connection block
One user manual

Note: The ST-PTZ-RC handheld infrared remote controller requires 2 AAA batteries (not supplied).
The PT Dome Controller requires a 12VDC 1A power supply (not supplied) such as the
Securitytronix ST-PS12VDC1A.

PRODUCT DESCRIPTION

The ST-PTZ-RC is a consumer grade pan, tilt, zoom (PTZ) controller designed for PTZ dome
cameras. The ST-PTZ-RC comes with one PT Dome controller allowing PTZ control of up to 255
PTZ cameras.

SPECIFICATIONS

ST-PTZ-RC

Specifications (Typical)

1. Communications Protocol

RS-485

2. Baud Rate

1200, 2400, 4800, 9600BPS

3. Camera Protocol

PELCO-D, PELCO-P

4. Power

2 AAA batteries for handheld remote (not supplied)
12VDC 1A power supply for PT Dome Controller (not supplied)

IMPORTANT NOTE

PTZ controllers are designed to perform a wide variety of PTZ camera control functions.
However, the utility of any PTZ controller is highly dependant upon the particular PTZ
camera to be controlled as each camera has not only its own functions but specific
methods of how those native functions are accessed and managed. Further, a particular
PTZ controller’s terminology may differ from that used by a particular PTZ camera.
Therefore, it will be necessary for the installer and/or user to consult BOTH the PTZ
controller and PTZ camera’s user manuals to ensure proper set-up, configuration and
application.

3

INSTALLATION AND OPERATION

1. UNPACKING and HANDLING

Each unit is shipped assembled and factory tested.

Ensure that all accessories are removed from the container before discarding packing material

2. MECHANICAL INSPECTION

Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or Securitytronix at 1-610-429-1511 for
assistance.

3. SPECIAL ATTENTION

a. The installer must comply with electrical safety standards. There must be sufficient

space between the PT Dome Controller and the camera’s communication and power
lines, power supplies and video lines and any high voltage equipment and/or cables.

b. Do not open up or dismantle the ST-PTZ-RC or the PT Dome Controller’s cases.

There are no serviceable parts inside the unit.

c. Do not install ST-PTZ-RC or the PT Dome Controller in an environment where the

temperature is above 104° F.

d. Do not install the ST-PTZ-RC or the PT Dome Controller in a damp environment.

e. Only use a dry cloth to clean the units. If there is dirt that is difficult to remove wipe

gently with a mild detergent. Never use strong or abrasive detergents.

f. A minimum 12VDC 1A power supply must be used. AC power cannot be applied.

Using an AC or other incorrect power supply will damage the unit. The SecurityTronix
ST-PS12VDC1A power supply is recommended.

g. Only qualified installers are allowed to install, test and disassemble the ST-PTZ-RC

and the PT Dome Controller.

h. As the ST-PTZ-RC and PT Dome Controllers are sensitive devices any shock or

collision to the units or shaking of the units will cause damage and void the warranty.

4. PRODUCT PICTURES