Security Tronix ST-IP-BT1VF-PRO, ST-IP-BT2VF-PRO, ST-IP-D1VF-PRO, ST-IP-D2VF-PRO Operating Instructions Manual

IE Operating Instruction Manual

1

IE Operating Instruction Manual

ST-IP-BT1VF-PRO
ST-IP-BT2VF-PRO

ST-IP-D1VF-PRO
ST-IP-D2VF-PRO

IE Operating Instruction Manual

2

CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this

unit. No user serviceable parts are inside.

CAUTION: To prevent electric shocks and risk of fire hazards, only use the recommended

power supply type.

1. UNPACKING and HANDLING

Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container before discarding packing material

2. MECHANICAL INSPECTION

Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or SecurityTronix at 1-610-429-1511 for
assistance.

3. SPECIAL ATTENTION

a. The installer must comply with electrical safety standards. There must be sufficient
space between the camera’s power supply and video line and any high voltage
equipment and/or cables.
b. To help ensure the camera’s life and proper operation do not point the camera
towards the sun or strong light.
c. Do not install the camera in an environment where the temperature is above 113° F.
d. Do not install the camera near a magnetic field or a high-power motor.
e. Do not mount the camera near a radiator or heater.
f. Only use a dry cloth to clean the camera. If there is dirt that is difficult to remove wipe
gently with a mild detergent. Never use strong or abrasive detergents.
g. A minimum 12VDC 1000mA or POE AF(48V DC) must be used. AC power
cannot be applied. Using an incorrect power supply will damage the camera.
h. Only qualified installers are allowed to install, test and disassemble the camera.
i. The IR LED angle and lens viewing range are adjusted at the factory. Any change to
the camera’s lens will affect image quality.
j. The camera is a low voltage product. If installed outdoors proper safety and
lightning grounding are required.

IE Operating Instruction Manual

3

Contents

1. Brief introduction of IE browsing operation ................................................................................. 4

1.1. Installation of plug-ins and login ....................................................................................... 4

2. IE menu introduction .................................................................................................................... 5

2.1 Home ................................................................................................................................... 5

2.2 Replay ................................................................................................................................. 6

2.3 Parameter Setting ................................................................................................................ 7

2.3.1 Video setting ............................................................................................................. 7

2.3.2 OSD setting .............................................................................................................. 8

2.3.3 PTZ setting ............................................................................................................... 8

2.3.4 basic settings ............................................................................................................ 8

2.3.5 DDNS setting ........................................................................................................... 9

2.3.6 E-Mail setting ......................................................................................................... 10

2.3.7 Wifi setting ............................................................................................................. 11

2.3.8 P2P setting .............................................................................................................. 11

2.3.9 Motion Detect setting ............................................................................................. 12

2.3.10 Occlusion Detect setting ...................................................................................... 12

2.3.11 Alarm in out setting .............................................................................................. 13

2.3.12 Auto capture setting .............................................................................................. 13

2.3.13 Record setting ...................................................................................................... 13

2.4 System ............................................................................................................................... 13

2.4.1 User setting ............................................................................................................ 14

2.4.2 Time setting ............................................................................................................ 14

2.4.3 Initialize setting ...................................................................................................... 15

2.4.4 Device Info setting ................................................................................................. 16

2.4.5 Storage Device setting ............................................................................................ 16

2.4.6 System log setting .................................................................................................. 16

IE Operating Instruction Manual

4

1. Brief introduction of IE browser
operation

The Securitytronix IP-PRO series IP cameras have a built in web server and can be accessed using

Internet Explorer.

1.1. Installation of plug-ins and login screen

(1) Run IE and input the video camera’s IP address and HTTP port in the URL bar.
(2) After successfully connecting to the camera’s web server, a login page will appear. Enter a username and
password (Both the default username and password are “admin”).
(3) Choose the language; either English or Chinese.
(4) Stream: through this option, you can select to preview the main flow or the minor flow of the video
camera.
(5) Click the link ‘Download Player’ to download the player when logging in for the first time.
(6) After the control is loaded, please log in to the video camera again (if you do not want to log in
repeatedly, you can select “Auto login”); and images of the video camera are displayed in the preview
window.

IE Operating Instruction Manual

5

2. IE menu introduction

The IE (Internet Explorer) interface of the video camera is mainly composed of several main functions

There are two options at the upper right hand of the IE interface; “Download Player” to download the

necessary control and “logout” to log out of the IE interface.

2.1 Home

The Home menu is opened by default after logging in. The video image will appear in the center of the screen.

Function buttons are located above the images. An operating panel is located at the right side of the image and the
detailed functions are as follows:

Recording button: Video recording is started after clicking the button; red points will occur in a

previewed image to show that the recording is in process; video recording is ended by clicking the button again;
the video is stored in the SD card (if equipped), or in an AVI format. The recorded document not only can be
played by a player which supports H/.264 code, but also can be played by the AviReplayer of the video camera.

Snapshot button: By clicking the button, you can take a screen shot.

Talkback button: By clicking this button, sound from the client computer end can be sent to the

video camera; talkback icon will show in the previewed image when the talkback function is turned on; the
talkback is turned off by clicking the button again.

IE Operating Instruction Manual

6

Voice button: by clicking the voice button, the sound function will be enabled (3rd party audio

equipment is needed for audio function); a voice icon will appear in the previewed image when the voice button is
turned on; and the voice is turned off by clicking the voice button again.

Note: some functions in the control panel are for PTZ function

2.2 Replay

The replay interface is only used for SD card of the video camera (If equipped).

Vertical/Horizontal

Auto scan

PT direction control keyboard

Hue adjustment

Brightness adjustment

Contrast adjustment

Color saturation adjustment

PT rotational speed

control

Scene Setting

Stream Setting

Image Setting

Power Configuration