Securitron Vista V2M1200, Vista V2M1290 Installation Instructions Manual

1

500-33705, Rev A

V2M1200/1290 Series Maglock

Installation Instructions

Securitron
Phoenix, AZ 85044
Tel: [phone]
Mon-Fri: 6:00am - 4:00pm PDT
Fax: [phone]

www.securitron.com

2

500-33705, Rev A

Table of Contents

Product Information ................................................................................ 3

Electrical .............................................................................................. 3

Product Type ....................................................................................... 3

LED Operation Colors for V2M1200/1290 with MBS .................... 3

Recommended Tools ............................................................................. 3

Ensuring Correct Voltage Setting ........................................................ 4

Installing the V2M1200/1290 on an Out-Swinging Door .................. 4

Determining the Door Frame Header .............................................. 4

Installing the Armature Plate on a Solid Door ................................ 5

Installing the Armature Plate on a Hollow Door ............................. 5

Installing the V2M1200/1290 on an In-Swinging Door ..................... 6

Wiring the V2M1200/1290 .................................................................... 9

Electrical Specifications ..................................................................... 9

Typical Magnetic Lock Wiring ........................................................... 9

Wire Gauge Chart .............................................................................. 9

Magnetic Lock Care and Maintenance ............................................. 10

Troubleshooting .................................................................................... 10

VistaCare Warranty .............................................................................. 11

3

500-33705, Rev A

Product Information

Holding Force

1200 lbs (544 Kg)
Dimensions (L x W x H)
10-1/2” x 2-7/8” x 1-9/16” [266 mm x 72 mm x 40 mm]

Electrical
NOTE: Factory default setting is 24 VDC.

12 VDC and 24 VDC operation (field selectable via voltage selection
switch in the wiring compartment)

Product Type
NOTE 1: The V2M1200/1290 Series with Magnetic Bond Sensor

(MBS) uses a hall-effect sensor.

NOTE 2: The V2M1200/1290 Series with Door Position Switch (DPS)

uses a change-over reed switch sensor.

Besides the unmonitored version, the V2M1200/1290 Series Maglock is
available with either a MBS, a DPS, or both.

LED Operation Colors for V2M1200/1290 with MBS

The LED operation color can be set in the field. Colors can be reversed
by reversing the two-pin plug connection on the Printed Circuit Board
(PCB). The factory default setting is as follows:

LED indicator OFF No power to the magnet
LED indicator RED Power on magnet, door open
LED indicator GREEN Power on magnet, door closed

Recommended Tools

Screwdriver, #2 Phillips Center Punch
Drill Drill Bit: 15/32” [12 mm], 5/8” [16 mm],
Tap: ¼”-20 UNC [M6-1.0]

4

500-33705, Rev A

Ensuring Correct Voltage Setting

NOTE: Factory default setting is 24 VDC.

1. ENSURE the onboard PCB is set for the correct and desired

operating voltage.

2. IF a change is required,

THEN ACCESS the wiring compartment by removing the wiring
compartment Phillips head screw and cover (see
Figure 1, “Wiring Compartment”),

AND TOGGLE the 12V/24V slide switch to the desired position.

Figure 1. Wiring Compartment

3. REPLACE the cover and Phillips head screw.

Installing V2M1200/1290 on Out-Swinging Door

Determining the Door Frame Header

1. DETERMINE the type of door frame header and whether a filler

plate, header bracket, or angle bracket is required for installation
(see Figure 2, “Door Frame Installation Options”).

Figure 2. Door Frame Installation Options