Securifi Peanut Plug PP1-WHT-US Quick Start Manual

Peanut Plug - Quick Start Guide

MODEL : PP1-WHT-US

Adding to Almond

1. Peanut Plugs must be added one at a time.

2. Insert the Plug into a power outlet. If the LED is not blinking, Reset the Plug as per below instructions and
then start over from Step1.

3. On the Almond touchscreen, tap the Add Sensor icon and then tap Add. The touchscreen should now
display the message “Adding sensor…”

Resetting the Peanut Plug

Reset the Plug by pressing the pairing button (<Button Symbol>) for 10 seconds and then releasing it.
Remove the Plug from the power outlet and plug it back in.

Monitoring & Controlling the Plug

1. The Toggle button (<Button Symbol>) on the Plug can be used to manually switch the plug and its attached
appliance on and off.

2. The Plug can also be monitored and controlled via the Internet using our free Almond iPhone and Android
apps or from a standard web browser (http://connect.securifi.com).

3. In case the Almond can’t access the Internet, you can also monitor the Peanut Plug via the Connected
Home app on the Almond’s touchscreen or via the Almond’s local web user interface (default:
http://10.10.10.254)

Operating Conditions

Indoor Use Only
Temperature: 0 to 40C (32 to 104F)
Humidity: 0 to 80%
Altitude: Up to 2000m (6500 ft)

Caution

1. Make sure the Peanut Plug is OFF before plugging an electric appliance into it.

2. Unauthorized changes or modifications to the Peanut Plug will void its warranty and could seriously
compromise its safety or efficacy.

3. Protective earthing: Ground pin must not be removed from the device.

4. Make sure an active Peanut Plug is easily accessible and can be disconnected quickly.

5. Unplug device prior to cleaning. Use dry cloth on exterior of the device. To avoid shock hazard and/or
damage to device, DO NOT use any liquid solution.

6. Install and use Peanut Plug in accordance with the appropriate Electrical Codes and Regulations

7. Do not install near heat sources or in humid areas

8. When operating under heavy loads, the Peanut Plug may heat up considerably. Allow it to cool before
manually removing it from an electrical outlet.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

●

Reorient or relocate the receiving antenna.

●

Increase the separation between the equipment and receiver.

●

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

●

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this

equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

This device and its antenna(s) must not be co-located or operation in conjunction

with any other antenna or transmitter.