TECHNICAL SUPPORT
Secure Wireless 866-908-Tech
www.mysecurewireless.com
KEYFOB ENROLLMENT PROGRAMMING
A - *0
C - *2
E - *4
B - *1
D- * 3
F - * 5
REPLACING THE BATTERY
MODEL
SW-NAP-PAN
FCC ID
QNP-PAN319
FREQUENCY
319.5 MHz
WARRARTY
Limited Life Time
BATTERY
CR2032 Replace with
Panasonic
MANUAL PART #
200-10002 Rev A
USING PANIC ACCESSORIES
1. Open the case with a
flathead screw driver
WRIST-STRAP
2. Choose NECK-STRAP
Open the case using a flathead screwdriver. (+) should
be facing up. . Re-assembly by pressing the board into
place firmly and re-attach with the screw. Snap case
back together.
FCC Compliance
This device complies with Part 15 FCC Rules. Operation
complies with the following 2 conditions (1) This device
may not cause harmful interference and (2) this device
must accept any interference received, including
interference that may cause undesired operation
SW-NAP-PAN
Single Button Panic
NAPCO CAMPATIBLE
INSTALLATION MANUAL
taken out of the box.
firmly
pressing together
bottom case by
3. Attach the new
case
or WRIST-STRAP
bottom that is on the remote when
The other accessories can be used with the standard case
NECK-STRAP
n the
Alpha Chart
keypad after disarm
Note : Panic trouble must reset at
6. Push On/Off to Save
5. ENTER Point “3” – for Panic
Serial ID
back on unit. Digit that follows “:” o
4. ENTER Check sum (0-9 ; A-F) (located on
of unit)
3. ENTER 6 Digit Id Number ( located on back
2. SELECT Zone #
1. ENTER Panel Programming
For WRIST-STRAP or NECK-STRAP:
SW-NAP-PAN.
allow for a variety of uses for the
The SW-NAP-PAN is equipped with an accessory pack to
replacement for using the programming instructions.
should only be used as a reference and not as a
should be consulted for that panel. The below guide
For a detail programming guide, the instruction manual
Loading...