Page 1
1
Important:
● For indoor use only.
● Battery Low Voltage: 5.2 ± 0.2V. The display will alert low battery when battery voltage
reaches 5.2±0.2V. PLEASE REPLACE THE BATTERY IMMEDIATELY.
Battery Replacement Instructions
One 9V alkaline battery is installed in the SureLock Battery Management compartment in the
bottom of the –II series EntryPad.
To replace the battery, pull out the battery compartment first.
Follow these steps:
o Release the latch of the battery compartment, by pulling lever
downward, See Fig. 2.
o Pull out the battery compartment from the bottom of the EntryPad,
See Fig. 3.
Doc.No.:BSU-EC0601AII130402
Version No.: V1.01 USER
SafeLogic Basic Operating Instructions
This manual is for the SafeLogic Basic EntryPad, EC-0601A-II, with SureLock Battery
Management system, used in conjunction with EL-0601, EL-0701, EL-0801 or EL-0901 lock bodies.
Page 2
2
o Take out the battery and replace with a new 9V alkaline battery
(Duracell and Energizer brands are recommended). The battery
compartment will receive the battery, orienting the positive and
negative terminals correctly. See Fig.4.
o Put the battery compartment back into the entrypad. Push up the latch of the
battery compartment until it snaps closed. See Fig. 1.
FEATURES:
1. Manufacturer default code is 1-2-3-4-5-6
2. Function of Code
a. Unlock safe lock system
b. Change code
3. Wrong Entry Penalty (Penalty Time)
Entry of four (4) consecutive invalid codes results in a 5-minute penalty time period.
a) The unit beeps at 5 second intervals indicating that it is still in the penalty time period.
b) While the system is in penalty time, the EntryPad buttons remain unresponsive.
Pressing buttons during penalty will not restart or lengthen the penalty time period. It
will continue to count through the 5 minute penalty time period.
c) While the system is in penalty time, removal of the batteries will interrupt the penalty time
countdown. Upon reinstallation of the batteries, the EntryPad continues to count down
until the 5 minute penalty time period expires.
4. Standby Status
In order to conserve battery power, the system will revert to standby status if there is no key
press within 10 seconds. Standby status is indicated by two short beeps.
5. Automatic Re-lock
The safe lock system automatically relocks after 6 seconds of being opened by a valid
code.
6. Low Battery Alert
a) Repeated beeping (8 beeps) during an unlock operation indicates that the battery is low and
needs immediate replacement.
b) Manufacturer recommends the use of 9-Volt standard alkaline batteries (Duracell or
Energizer brands are recommend) replaced annually.
USER PROGRAMMING INSTRUCTIONS
1. ALWAYS PERFORM OPERATIONS WITH THE SAFE LOCK SYSTEM UNLOCK AND
THE SAFE DOOR OPEN.
Page 3
3
2. Before closing the door, make sure all the program changes are correct.
3. The system will not allow the User Code to be set to six zeros.
1. To Change Code
a) Enter “0” six times. Two beeps will sound, indicating the entry is valid and the system is
awaiting the code change.
b) Next, enter the existing six (6) digit code. Two beeps will sound, indicating the entry is valid.
c) Enter the new six (6) digit code. One beep will sound, indicating the entry is valid.
d) Re-enter the new six (6) digit code. One beep will sound, indicating the codes entered in
steps c and d are the same and the code changing process is successful.
e) If Three Beeps sound, the code change process has been unsuccessful. The existing code
is still valid. Repeat steps a to d.
Note:
a) Verify the new code at least 3 times before closing the door to make sure the code has been
programmed correctly.
b) The system will revert to standby status if there is no key press within 10 seconds.
Standby status is indicated by two short beeps.
Specifications：
Power Supply: DC 9V
Power Supply Range: DC 4.5V-12V
Standby Current : <50μA
Active Current: <20mA
Battery Low Voltage: 5.2±0.2V
Working Temperature: 0℃~ +49℃
Working Humidity (max): <90%
Code Length: 6 Digits
Mechanical System Life Span:
>10,000 Cycles (UL requirement)
>100,000 Cycles (SecuRam design criteria)
SecuRam Systems Inc. U.S.A.
Loading...