Second Wind 2414, 2414-S Installation Manual

Second Wind Air Purifiers

Installation Manual

2414

2414

-

S

24 Volt

Remote Units

All Second Wind air purifiers are designed to address Heat

-

ing and Air Conditioning air handling units. Second Wind

air purifiers use ultraviolet germicidal light at a frequency

of 254 nanometers to disinfect biological growth in return

or supply air stream . Some key features of the Second

Wind 24 volt series:



24 volt water proof ballastenclosure



Allows greater installation flexibility



Multiplelamplengths (14 inches)



Electronic start 24 volt power supply



Improves efficiency, reduces maintenance



High intensity lamps



Patented Photo

-

catalytic oxidation process

avaliable



Over 9000 hourslampexpectancy



Limited Lifetime ballast and unit warranty



Four year lamp warranty

Please read all instructions carefullytohelp ensure a correctand SAFE installationof your

SecondWind purifier

(Ultraviolet Germicidal Photo

-

catalytic Air Purifier). Failure to do so could damage the equipment or cause harm

to yourself or others. Only qualified Heating Ventilation and Air Conditioning (HVAC) technicians should per

-

form the ins

tallation.

WARNING

Ultraviolet (UV) light can be harmful to eyes and skin,

causing loss of sight and sunburn. When installing do

not put unit in an area that allows the UV lamp to be

visible . Turn off electrical service before servicing

unit.

Electrical shock hazard from 24 volt or 120/277 VAC

may cause serious injury or death. Disconnect power

before starting installation or maintenance.

Each UV lamp contains a small amount of mercury, in

case of breakage use proper disposal techniques.

(pg.5)

Wear protective gloves and safety glasses when han

-

dling lamp. To prevent injury, unplug lamp connector

and allow to coolfor10minutes before servicing.

CAUTION

1. Ultraviolet (UV) light can cause the degradation

of plastics, rubber, and other no

n-metallic materi

-

als without uv

-

inhibitors, used in the HVAC sys

-

tem.



Install unit in location that prevents exposure to

plastics, rubber, and other non

-

metallic materials

to UV light, or shield such materials with alumi

-

num tape, sheetmetal, or meta

l conduit.



If equipment or components are not made of UV

resistant materials shield with aluminum tape or

sheet metal.

2. Ultraviolet lamps



Failure to remove fingerprints from lamp could

shorten their lifespan. (clean with denatured alco

-

hol)Dispose of broken and replacement lamps at your

local waste management office. For information

o n l o c al disp o s a l l a w s r e fer t o

www.lamprecycle.org

Index:

Page

Product

2

Safety Procedures

2

Mounting Location

3

Tools

3

Installation

Installation Remote Lamps

Lamp Replacement/Disposal

And Parts List

Troubleshooting

Warranty

45677&8

1.

Install the lamp where you have easy access.

2.

Make sure before drilling into equipment that there is nothing in the way that would be damaged.

3.

Thelamp should beinstalled a minimum of2

-

3 inches, maximum 36 inches awayfrom the coilor pan

surface.

4.

When looking for a mounting location try to install the unit away from non UV resistant plastics, rubber,

and other non metallicmaterials. Shield th

ese components using sheet metal, aluminum tape,or metal con

-

duit.ElectricDrill

•

Tape measure



Phillips screwdriver

•

Aluminum tapeand sealant



Tin snips

•

Multimeter



Eye protection