Seco-Larm VS-1V12BQ User Manual

VS-1V12BQ

Video Surge Protector

Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.

Installation Manual

 Helps prevent damage to sensitive CCTV equipment such as cameras, monitors,

digital video recorders, and video splitters

 Intercepts repeated surges and grounds that could damage video equipment
 Helps protect against power surges or lightning strikes
 Passive operation – No external power required
 Gold-plated BNC connector improves reliability and product life
 Includes a 16” grounding wire for convenient connection to ground

ENFORCER Video Surge Protector

The ENFORCER Video Surge Protector is a passive device that helps prevent damage to sensitive
CCTV equipment from power surges or lighting strikes. The device can be deployed in new
installations or added to existing installations.

The ENFORCER Video Surge Protector should be installed between a camera and a digital video
recorder or video splitter to protect against surges that could damage video equipment.

NOTE: For the best protection, it is recommended that two video surge protectors be installed, one
near the camera, and one near the DVR.

Introduction:

Bandwidth

0~1GHz

Maximum input

1.0Vp-p

Insertion loss

<0.2dB

Return loss

16dB @ 75Ω

Frequency response

0-3dB at 10MHz

Isolation voltage

600VDC (min.)

Insulation resistance

10,000 MΩ

Maximum surge voltage

4KV

Surge life

300 surges @ 100A

Surge protection time

1ns

Surge resistance

Approx. 0Ω

Power passing capability

130 VAC/DC, 65 V

RMS

@ 10A

Connector

In

BNC Male

Out

BNC Female

Impedance

75 Ω (BNC-to-BNC)

Dimensions

31/16” x 1” x 1” (78 x 25 x 25 mm)

Cable length

16” (406mm)

Weight

2.3-oz (65g)

Material

ABS Black

Operating temperature

32° ~ 131°F (0° ~ 55° C)

Specifications:
Installation:

1. Detach the video cable BNC connector from the camera BNC connector.

2. Attach the equipment end (male connector) of the first video surge protector to the camera BNC connector.

3. Attach the video cable BNC connector to the cable end (female connector) of the first video

surge protector.

4. Connect the ground wire from the first video surge protector to an earth ground.

5. Detach the video cable BNC connector from the DVR/Multiplexor BNC connector.

6. Attach the cable end (female connector) of the second video surge protector to the video cable

BNC connector.

7. Attach the DVR/Multiplexor BNC connector to the equipment side (male connector) of the second video

surge protector.

8. Connect the ground wire of the second VS-1V12BQ to the metal chassis of the protected equipment.

2 SECO-LARM U.S.A., Inc.