Seco-Larm VS-1AHHAQ User Manual
VS-1AHHAQ
Manual
HDMI Surge Protector
Helps prevent damage to sensitive HDMI equipment such as
players, monitors, and projectors
Intercepts repeated surges and spikes that could damage
HDMI A/V equipment
Built-in ESD, EFT
Reaction speed <1ns
Passive operation – no external power required
Includes a 12‖ (30cm) grounding wire for convenient connection to
ground
ENFORCER HDMI Surge Protector
To HDMI
Input
Unprotected
End
1" (26mm)
To HDMI
Output
Protected
End
23/16" (56mm)
Grounding Wire
Attachment Location*
(One on each end)
1" (26mm)
* Note: There is a ‘Grounding Wire Attachment Location’ included on both ends of the HDMI Surge
Protector. Grounding wire can be attached to either of these locations.
Introduction:
The ENFORCER HDMI Surge Protector is a passive device that helps protect sensitive HDMI
equipment from power surges. The device can be deployed in new installations or existing
ones.
The ENFORCER HDMI Surge Protector should be installed between HDMI equipment such as
players, monitors, and projectors to protect against surges that could damage the video
equipment.
NOTE: For the best protection, installing two surge protectors is recommended: one at each
end of the cable.
ESD protection
15kV (ESD), 8kV (Contact)
EFT protection
40A (5/50ns)
Surge protection
5A (8/20ns)
Surge reaction speed
<1ns
Connector
In
HDMI
Out
HDMI
Dimensions
23/16"x1"x1" (56x26x26 mm)
Weight
1.2-oz (35g)
Material
Aluminum
Operating temperature
32°~131°F (0°~55° C)
Specifications:
Overview:
1x
HDMI Surge Protector
2x
Mounting screws
1x
12" (30cm) grounding wire
1x
Manual
2x
Plastic wall anchors
1x
Grounding wire screw
Parts List:
2 SECO-LARM U.S.A., Inc.
Loading...