4K HDMI
®
Switchers
Manual
Add up to five HDMI inputs to almost any
high-definition TV or HDMI display
Supports up to 4K/2K resolution and 3D video
Individual status LEDs for each HDMI input
Switch will automatically select the active
input for added convenience
Includes remote control for switching
between inputs
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United
States and other countries.
4K
3D
Support
Support
MVS-AH31-01NQ
4K 3x1 HDMI Switcher
MVS-AH51-01NQ
4K 5x1 HDMI Switcher
MVS-AH31-01NQ
MVS-AH51-01NQ
ENFORCER 4K HDMI Switchers
The ENFORCER 4K HDMI Switchers allow easy switching between multiple HDMI sources. The
switchers work with most HDMI devices, delivering the very best in digital audio and video signals
with HD resolutions of up to 4K/2K. An included remote control easily switches between HDMI
sources. LED Indicators clearly display the HDMI source being used. The switcher will automatically
select the active input for added convenience. The 4K HDMI Switchers can be daisy chained up to
four levels for even more inputs.
Introduction:
Model
MVS-AH31-01NQ
MVS-AH51-01NQ
Type
HDMI Switcher
Input video signal
3.3V
Input DDC signal
5Vp-p (TTL)
Maximum single link range
4K*2K@30hz
Deep color
48bit
Video formats supported
High-speed HDMI, HDCP 1.4
Audio formats supported
LPCM, Dolby-AC3, DTS7.1, DSD
Output video
HDMI
Resolutions supported
4K/1080p/1080i/720p/576p/576i/480p/480i
Video amplifier bandwidth
10.2Gbps
Video input connector
3x HDMI Type A 19-pin female
5x HDMI Type A 19-pin female
Max. input cable length
24AWG (15m), 26AWG (10m), 28AWG (5m)
Video output connector
1x HDMI Type A 19-pin female
Max. output cable length
24AWG (15m), 26AWG (10m), 28AWG (5m)
IR pass-through
38kHz
Operating voltage
5VDC
Power supply
USB Power
ESD protection
±8kV (air-gap discharge), ±4kV (contact discharge)
Current draw
150mA@5VDC
250mA@5VDC
Operating temperature
32°~104° F (0°~40° C)
Operating humidity
20~90% RH (no condensation)
Dimensions
37/16"x23/8"x3/4" (87x60x19 mm)
Weight
2.1-oz (60g)
Specifications:
1. Determine the location where the HDMI Switcher will be installed in relation to the HDMI sources and
HDMI display.
2. Plug the HDMI sources into the HDMI connector inputs on the front or back of the switcher.
3. Plug the HDMI display into the HDMI connector output on the front of the switcher.
4. Plug the USB power cable into the switcher and the other end into a powered USB port on the display or
one of the sources.
5. Plug the IR receiver dongle into the IR receiver port and place in view of the HDMI display
6. Turn the power on the HDMI sources and display device. Using the included remote or selection button
on the switcher, change the HDMI sources going to the HDMI display.
Installation:
2 SECO-LARM U.S.A., Inc.
ENFORCER 4K HDMI Switchers
Sample Application:
HDMI Display
HDMI Sources
HDMI Switch Remote
IR RX
Cable Legend:
HDMI
Power
IR
For maximum cable length, see Specifications.
Parts List:
HDMI Sources
Overview:
Remote
* MVS-AH51-01NQ only
Switcher
37/16"
(87mm)
23/8"
(60mm)
3
/4"
(19mm)
33/8"
(86mm)
19/16"
(40mm)
1x 4K HDMI Switcher
1x Remote control
1x Remote control battery
1x USB power cable
1x Manual
1x IR receiver
IN1
IN2
IN3
IN5
IN4
USB power cable
SECO-LARM U.S.A., Inc. 3
ENFORCER 4K HDMI Switchers
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to
change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2016 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in
normal service for the one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the
repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is
void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
PICHN3
Tel: (949) 261-2999 | (800) 662-0800
Email: sales@seco-larm.com
MI_MVS-AHx1-01NQ_160226.docx
Troubleshooting:
HDMI Device does not function correctly.
Make sure the switcher is powered.
Make sure the source(s) and display are
powered.
Make sure that there are no problems with the
HDMI source, HDMI cables, or HDMI display by
plugging a source directly into the display using
the HDMI cables.
Make sure that the source(s) and display are
plugged in to the correct connectors.
Make sure the HDMI source(s) are compatible
with the HDMI display.
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing
LLC in the United States and other countries.
Also Available from SECO-LARM®:
4K HDMI Splitters
MVD-AH12-01Q
2 HDMI outputs
MVD-AH14-01Q
4 HDMI outputs
MVD-AH18-01Q
8 HDMI outputs
Supports 3D video
Supports 4K resolution
EDID management settings
High-Speed HDMI Cables
MC-1102-18NQ
1.5ft (0.5m), 28AWG
MC-1102-03FQ
3ft (1m), 28AWG
MC-1102-06FQ
6m (1.83m), 28AWG
MC-1102-10FQ
10ft (3m), 28AWG
MC-1102-16FQ
16ft (5m), 28AWG
MC-1102-20FQ
20ft (6m), 26AWG
MC-1102-25FQ
25ft (7.6m), 26AWG
MC-1102-30FQ
30ft (9m), 26AWG
MC-1102-50FQ
50ft (15m), 26AWG
Supports 3D video
Supports 4K
resolution
Supports Ethernet
Lifetime warranty
MVD-AH14-01Q shown
4 SECO-LARM U.S.A., Inc.
Loading...