Seco-Larm MVE-PCW15Q, MVE-PC015Q User Manual
ENFORCER Component Video Baluns
Troubleshooting:
Component video balun does not
function correctly
Also Available from SECO-LARM:
Passive Audio Baluns
y
Make sure all input and output connections are
connected firmly to the
y
Make sure the video input device is turned on
y
Make sure the video output device is turned on
y
Test the Cat5/6 cable between the baluns
y
Make sure the IR/Audio transmission switch is set
to the correct position
HDMI over Cat5e/6
balun
3.5mm Stereo Balun
MAE-P115-01Q
(shown)
MVE-AH010Q
MAE-P317-01Q
SECO-LARM has a complete line of audio/video products.
Please visit www.seco-larm.com for more information.
Component Video Baluns
with Programmable Digital Audio or IR Transmission
MANUAL
WARRANTY This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is
limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM.
This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect,
repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines
that such equipment is not operating properly as a result of causes other than defects in material and workmanship.
The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only,
at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damages of any kind to the purchaser or anyone else.
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right
to change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2009 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in
whole or in part, without the written permission of SECO-LARM.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
4 SECO-LARM U.S.A., Inc.
®
U.S.A., Inc.
Website: www.seco-larm.com
E-mail: sales@seco-larm.com
mi-MVE-PCx12-5Q.docx
MVE-PW015Q
Wall Plate
The ENFORCER MVE-PC0 Series of Component Video Baluns extends the range of traditional
component video (YPbPr or RGB) signals. Used in pairs, the baluns use a single Cat5e/6 Cable to
deliver HD resolutions up to 1080p and a single digital audio or IR signal distances of up to 160’
(50m), or up to 1000’ (300m) for 480i. The MVE-PC0 Series can also be programmed to transmit
an additional digital single audio or IR signal.
PITSW4
MVE-PC015Q
Standard
ENFORCER Component Video Baluns
A
A
A
A
k
A
A
A
or
Features:
• Send component video and digital audio
signals over a single Cat5e/6 cable
• Wall or desktop versions available
• Passive operation: No power required
Specifications:
1080p 160’ (50m)
Max. range
Video format YPbPr or RGB (1080p/1080i/720p/720i/480p/480i)
Maximum input 1Vp~p
Insertion loss
Return loss
Auido / Video
Common mode rejection -60 dB maximum
Bandwidth
Power No power required
Wire type UTP (unshielded twisted pair)
Wire category
Connectors
Connections
ttenuation DC ~ 5 Mhz, 1.5 dB max
Dimensions
Weight
Humidity range 0 ~ 95%
Other
Temperature Range 14°~165°F (-10°~74°C)
Case
Overview:
480i 1,000’ (300m)
udio 900’ (280m)
Audio
Video 0.8 dB for 0.1 MHz. increases to 4.0 dB over the frequency range
udio Greater than 14 dB over the frequency range
Video Greater than 14 dB over the frequency range
udio 60 MHz, 4 dB roll off
Video 25 MHz, 1.5 dB roll off
Input RC
Output RJ-45 See pin configuration on page 3
Wall-plate 41/2" x 27/8" x 15/8" (115 x 73 x 41 mm) without plate
Standard 3" x 2 5/8" x 1" (76 x 67 x 25mm)
Wall-plate 3.4 oz
Standard 5.0 oz
Wall-plate PC plastic
Standard
RCA video
connectors
RCA audio
connectors
• Gold-plated RCA connectors
• Programmable digital audio or IR transmission
• Supports HDTV signals up to 1080p
• Single RJ-45 output connector
Less than 1.5 dB over the frequency range
20 - 24 AWG @ screwless terminal blocks
CAT5e or CAT6 for improved range
/ Terminal bloc
luminum
RCA audio
connectors
RCA video
connectors
ENFORCER Compnent Video Baluns
Installation:
NOTE: The component video baluns MUST be used in pairs.
1. Mount and install the baluns where the video inputs and outputs can be easily accessed.
2. If using the included mounting plate, attach the plate to the balun using the included screws.
3. Connect the Cat5e/6 cable to the RJ-45 outputs on
RJ-45 Pin Configuration
the back of both baluns. Use T568B wiring
standard.
4. Determine whet her audio transmission or IR
transmission will be used, and set the Audio/IR
switch accordingly. See Sample Application 1 & 2.
5. Connect the male RCA plugs to the female RCA
inputs on the baluns.
6. If using IR transmission, connect the IR signal using
Connector Pins
Red (Pr) Pins 7 & 8
Green (Y) Pins 3 & 6
Blue (Pb) Pins 1 & 2
Digital audio or IR Pins 4 & 5
Use T568B wiring standard
the terminal blocks on the balun.
Sample Application #1: Using Audio Transmission
Up to 590’ (180m)
Amplifier
Sample Application #2: Using IR Transmission
MVE-PW015Q
MVE-PC015Q
NOTE: Baluns MUST be used in pairs.
IR/Audio switch
or
IR/Audio switch
set to Audio
set to IR
MVE-PC015Q
MVE-PW015Q
IR emitter
Component
video source
G
B
R
IR / digital audio
switch
(Front)
IR terminal block
MVE-PC015Q
RJ-45 connector
(Back)
RJ-45 connector
IR terminal block
MVE-PW015Q
2 SECO-LARM U.S.A., Inc.
MVE-PC015Q
MVE-PW015Q
or
IR control
module and
IR sensor
Up to 590’ (180m)
MVE-PW015Q
or
MVE-PC015Q
NOTE: Baluns MUST be used in pairs.
SECO-LARM U.S.A., Inc 3
Component
video source
Loading...