Page 1
®
MVE-AHMPM-41NQ
Manual
Features:
• Extends HDMI over one Cat5e/6 cable or
•
•
• IR Support (20kHz~60kHz)
•
•
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the
4K HDMI Extender over IP
IP network
Supports One-to-One, and One-to-Many
applications
Power adapters and IR hardware included
United States and other countries.
HDCP Compliant
Receiver (MVE-AHMPM-41NRQ) also
available separately
Page 2
ENFORCER 4K HDMI Extender over IP
The MVE-AHMPM-41NQ 4K HDMI Extender over IP extends the range of HDMI signals by using an active
transmitter and receiver to send video and audio over a single Cat5e/6 cable. The
supports IR signals using the included IR transmitter and receiver, allow
of an installation to control a device such as a media player or DVD player at the opposite end of the
installation. The MVE
connection of multi
1x
Transmitter
1x
IR Transmitter
2x
Power adapters
1x
Receiver
1x
IR Receiver
1x
Manual
Transmitter
MVE-AHMPM-41NTQ
Receiver
MVE-AHMPM-41NRQ
Maximum video resolution
4K@30Hz
Deep color
24-bit
Video formats supported
DTV/HDTV: 480i, 480p,576i,576p,720p,1080i, 1080p, 4K@30Hz
Cat5
262ft (80m)
Cat5e
328ft (100m)
Cat6
393ft (120m)
IP addressing
Static
IR frequency
20kHz~60kHz
Operating voltage
5VDC
Power supply
2A@5VDC
Power consumption
6W
4W
Operating temperature
32°~140° F (0°~60° C)
Dimensions
47/16"x15/16"x311/16" (112x23x94 mm)
Weight
5.9-oz (170g)
Specifications:
Overview
Introduction:
Parts List:
*Input/output are reversed on the transmitter
Cat5e/6 Input *
5VDC
Power LED
Status LED
Network LED
HDMI Output*
IR Input*
Reset
Receiver shown
-AHMPM-41NQ supports One-to-One, and One-to-Many installations, allowing the
ple units for extended range.
Model
Range – 4K
4K HDMI Extender over IP
ing remote control use from one end
2 SECO-LARM U.S.A., Inc.
Page 3
ENFORCER 4K HDMI Extender over IP
Installation:
Sample Applications — One-to-One:
Power
HDMI Display
Transmitter
IR RX
Remote
Receiver
For maximum cable length,
IR TX
HDMI Source
Power
Cable Legend:
Cat5e/6
1. Determine the location where the 4K HDMI Extender over IP units will be installed as well as how much
2.
3.
4.
5.
6.
, pointing the IR transmitter at
7.
Cat5e/6 cable will be necessary.
Connect the transmitter to the HDMI output of the source device.
Connect the transmitter and receiver:
a. If connecting One-to-One, connect one end of the Cat5e/6 cable to the transmitter and the other end
directly to the receiver.
b. If installing with a switch or router, connect one end of the Cat5e/6 cable to the transmitter and the
other end to a switch or router. Then, with a second Cat5e/6 cable connect the receiver to the other
end of the switch or router.
Connect the receiver to the HDMI input of the display or other device.
Connect one 5VDC adapter to the transmitter and the other to the receiver.
If remote control is desired:
a. Install the IR transmitter extension to the IR OUT port of the transmitter
the IR sensor of the device to be controlled.
b. Install the IR receiver extension to the IR IN port of the receiver, pointing the IR receiver in a direct
line of sight to where the remote control will be.
c. Point the remote control at the IR receiver when in use.
Switch on the HDMI source and display to verify that the system is functioning properly. It may take up to
a minute to sync up the video stream.
HDMI
Power
IR
Adapter
see "Specifications"
Adapter
SECO-LARM U.S.A., Inc. 3
Page 4
ENFORCER 4K HDMI Extender over IP
Sample Applications — One-to-Many, Switch/Router:
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: (949) 261-2999 | (800) 662-0800
Email: sales@seco-larm.com
PICLN3
MI_MVE-AHMPM-41NQ_210524.docx
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without
notice. SECO
1
SECO-LARM U.S.A., Inc. All rights reserved.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for one (1) year from the date of sale
to the original customer. SECO
returned, transportation prepaid, to
SECO
ect, repair or alteration, improper
or abnormal usage, or faulty installation, or if for
LARM determines that such equipment is not operating properly as a result of causes other
than defects in material and workmanship. The sole obligation of
ment or repair
only, at
LARM be liable for any special, collateral, incidental, or consequential personal or property damage of any kind
to the purchaser or anyone else.
IMPORTANT: Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws and statutes related to
monitoring and recording audio and video signals. SECO-LARM will not be held responsible for the use of this product in violation of any current laws or statutes.
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other
For maximum cable
HDMI Display
IR RX and Remote
HDMI
Display
Receiver
Power
Adapter
IR RX and
Remote
Power
Adapter
Receiver
LAN
Power
Adapter
HDMI Source
IR TX
Receiver
Power
Adapter
HDMI
Display
Transmitter
Cable Legend:
Cat5e/6
IR RX and Remote
California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information, go to www.P65Warnings.ca.gov.
HDMI
Power
IR
1
Switch
length, see
"Specifications"
2
1
3
countries.
-LARM. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, negl
SECO-LARM’s option. In no event shall SECO-
-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 202
SECO-LARM
4 SECO-LARM U.S.A., Inc.
-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is
any other reason SECO-
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replace
®
Loading...