
16842 Millikan Avenue, Irvine, CA 92606
Copyright 2015 © SECO-LARM U.S.A., Inc. All rights reserved.
r their respective owners.
right to change prices and specifications without notice. SECO-LARM is not responsible for misprints.
Phone: (949) 261-2999 | (800) 662-0800 Fax: (949) 261-7326
Website: www.seco-larm.com Email: sales@seco-larm.com
PI_E-961-S90W_150811.docx
Single Photobeam Detector
Through-beam photoelectric sensor
Red LED on for standby (TX) / Green LED show power (RX)
33.5mA (TX), 27.5mA (beam aligned) / 13mA (beam broken) (RX)
Horizontal +/-5°, vertical +/-5°
3
1/2
” x 2
3/8
” x 1
1/2
” (87 x 60 x 39mm)
The E-961-S90W is the easy-to-install way to protect large indoor and
outdoor openings as well as allow easy exit from areas protected by access
control equipment. When used as part of an alarm system, it can detect
vehicles along a driveway or entering a factory or similar sit
controlled access, such as a gated community or parking lot, the E
S90W allows a person or vehicle to open a gate without the use of codes or
unlocking devices.
e. For areas of
-961-
90 feet (30 meters) sensing distance for protecting large openings or
wide roadways.
Weather-proof to IP-66 standards for indoor and outdoor use.
Mounts flat or at a 90-degree angle to the wall with no need for extra
brackets.
Adjustable lens angle.
Transmitter power can be adjusted to match local environment.
1A relay output (N.O./N.C./COM).
AC/DC 10~24V operation, non-polarity connection.
Internal terminal block for easy wiring.
Mounting screws included.
1/2
3/8
1/2
®
The SECO-LARM policy is one of continual development. For that reason, SECO-LARM reserves the
All trademarks are the property of SECO-LARM U.S.A., Inc. o