Seco-Larm E-964-S50TB User Manual
E-964-S50TB
Multi-Frequency Single Photobeam
Manual
4 selectable frequencies to reduce interference
Small size for a less conspicuous installation
Simple to install
Signal strength indicator for easier alignment
Weatherproof for indoor/outdoor use (IP65)
Built-in AGC control to filter out lighting
disturbances
LED indicators for power, signal strength,
and trigger
Mounting hardware included
ENFORCER Multi-Frequency Single Photobeam
O N
1
2
Front
Side
23/8" (60mm)
311/16"
(94mm)
Overview:
113/16" (46mm)
Front Cover Removed
Transmitter
Receiver
Signal Strength LED
Alarm Indicator LED
Power LED
Wire Terminals
NC/NO Selector
Mounting Hole
Wire Hole
Channel Selection Switch
Mounting Hole
Channel
Selection Switch
Wire Hole
Wire Terminals
O N
1
2
Specifications:
Number of beam channels
Single infrared beam
Number of beam frequencies
4
Sensor range
3~50ft (1~15m)
Infrared LED wavelength
940nm
LED beam spread angle
Approximately ±10°
Interrupt speed*
50ms
Input power
10~24VDC
Current draw
(max)
Transmitter
15mA@12VDC
Receiver
30mA@12VDC
Relay output
NO/NC relay (set by jumper, default is N.C.) 0.5A@30VAC/VDC
LED (Transmitter)
Green - Indicates connected to power
LEDs
(Receiver)
Power (Green)
Indicates connected to power
Signal (Yellow)
Indicates receiver's signal is weak or beam is broken
Alarm (Red)
Indicates transmitter & receiver are not aligned or beam is broken
IP rating
IP65
Operating temperature
-13~131°F (-25~55°C) maximum humidity 95%
Dimensions
311/16"x23/8"x113/16" (94x60x46 mm)
Weight
2.6-oz (74g)
*This is the minimum time interval for breaking the beam which will trigger the output
Parts List:
1x
Transmitter
4x
Screws
1x
Manual
1x
Receiver
4x
Plastic wall anchors
V-
2 SECO-LARM U.S.A., Inc.
Loading...