Sears Telegames System Video Arcade 637.99743 Ownersmanual
Sears
SPORTS
home of theTed
CENTER
Williams brand
MODEL NO.
637.99743
assembly
operation
troubleshooting
replacement parts
OWNER'S
MANUAL
1977, Sears. Roebuck and Co.
Printed in
U.S.A.
0010*62
UNPACK
Console Unit
GAME
Paddle
Controllers
(Set of
2)
Joystick Controllers
AC Power Supply
Figure
1
System
is
page 3.
arget -Fun
i
Tele-Games Cartridge
TV/Game Switch Box
—
Parts of Sears Cartridge Tele-Games System Video Arcade
When you remove your Sears Cartridge Tele-Games
Video
Arcade from the box, you should have:
•
•
•
•
•
•
The only
a flat-head screwdriver.
Arcade
Video
Target-Fun Telegames Cartridge
2 Joystick Controllers (for
Fun Tele-Games Cartridge)
Set of 2 Paddle Controllers (for
additional Tele-Games
separately)
Console Unit
Cartridges, sold
use
with
AC Power Supply
TV/Game
Switch Box with twin-lead wires
needed
tool
to set up your
See further instructions on
the
use
Video
Target-
with
Arcade
INSTALL SWITCH BOX
Your TV/Game
television's
looks the most like the back of your television and
those instructions- A flat-head
your television has four screws
A. If
VHF antenna screws. Find the picture that
Switch Box attaches easily
screwdriver is required.
only:
1
9^"0*
BO* \
1\\\
o
\
2
Disconnect the twin-lead wire from the television
set and reconnect it to the
terminals on the TV/Game Switch Box.
2.
Connect
Switch Box to the VHF terminals or screws on
your television
If your television has a "U" shaped slider or a slide
B.
switch:
1
Move the "U" shaped slider to make
the twin-lead
set.
"300
wire from
•$u&+ 1
OHM" screw
the
TV/Game
300
OHM
connection
between the two screws.
OR
Push the slide switch to the side marked
OHM" or "300rr.
2.
If you have a round antenna cable,
Disconnect the cable from
it into the TV/Game Switch Box
plug
television and
the
at
OHM" connector.
OR
If you have a flat twin-lead antenna wire,
Disconnect it from the television
reconnect it to the
TV/Game Switch
Connect the twin-lead wire from the TV/Game
Switch Box to the VHF terminals
your television
"^
set.
"300
OHM" connector on the
Box.
set and
or screws
to
the
your
follow
"300
"75
on
C.Ifyour
1.
television has
If
have
you
short round cable:
a
round antenna cable,
a
Disconnect the long antenna cable from the
television set and reconnect it to the
"75
OHM"
connector on the TV/Game Switch Box.
OR
If you have a flat twin-lead antenna wire,
Disconnect it from the television set
reconnect it to the
"300
OHM"
TV/Game Switch Box.
2. Connect the TV's short loose-hanging cable to
the connector next to it on your television set.
3. Connect the twin-lead
Switch Box
the VHF terminals or screws on
to
wire
from the
your television set.
Plug the Game Cable from
console unit into the TV/Game Switch Box
connector. The TV/Game Switch Box can be left on your
television set permanently without affecting your television
your Video Arcade
program reception.
The TV/Game
permanently
•
Peel off the
to the
Switch Box can be attached
back of your television
protective
paper on the back
TV/Game Switch Box.
•
Press the exposed stick surface onto any clear
area on the back of your television set near the
antenna terminals.
Extra Switch Boxes
By attaching
television set in your home, you can easily move your
Video Arcade
from room to room. Extra
Boxes, part number 6-99726, are available through Sears,
Roebuck
Federal Communications
Require:
•
& Co.
Avoid using any longer twin-lead wire from
TV/Game Switch Box to
supplied with the TV/Game
•
Avoid connecting
TV/Game
cable-TV outlet.
•
Avoid attaching loose
when using
Any of the above may cause
television
Commission (FCC) regulations.
Switch Box
your
and is against Federal Communications
sets
TV/Game Switch Box to each
a
Commission Regulations
your television than is
Switch Box.
the twin-lead wire from the
any television antenna or
to
wires
Video Arcade.
your antenna terminals
to
interference to nearby
and
connector on the
TV/Game
the "Game"
at
set.
of
the
TV/Game Switch
the
Loading...