Sears 721.26082B Repair Manual
Repair services
America's repair specialists
SEARS KENMORE CANISTER
VACUUM CLEANER
MODEL: 721.26082B
FOREWORD [_oo_.,_,_°°_.]
BEFORE SERVICING THE UNIT, READ THE "SAFETY PRECAUTIONS" IN
THIS MANUAL.
MODEL 721.26082B
MECHANICAL SERVICE INFORMATION
TABLE OF CONTENTS
1. SAFETY PRECAUTIONS ................................................................................ 3
2. CAUTIONS ....................................................................................................... 3
3. DESCRIPTION/SPECIFICATIONS .................................................................. 4
4. DISASSEMBLY ............................................................................................. 5-7
5. TROUBLE SHOOTING ............................................................................... 8-10
6, BLOCK DIAGRAM/SCHEMATIC DIAGRAM/CIRCUIT DIAGRAM ................ 11
7. EXPLODED VIEW/REPLACEMENT PARTS LIST ................................... 12-16
1. SAFETY PRECAUTIONS
t i i i.i i_11,1,1,_
I MODEL 721 ,,26082B I
BEFORE OPERATING THIS VACUUM CLEANER, READ THIS SERVICE MANUAL THOROUGHLY,
AND OBSERVE EACH POINT CAREFULLY.
1. Empty the dust bin or clean the washable filter
in case the indicator moves toward red.
1) If the dust bin is full, intake power will be
reduced.
2) When the dust bin is full of dust, empty the dust
bin and clean the washable filter.
2. Filter
i) The filter is composed of a moter safety filter, an
exhaust filter, a washable filter and mesh screen..
2) Never use the vacuum cleaner without filters
It may harm to the motor,
3) When the cloth bag, the moter safety filter and
the exhaust filter are soiled, wash the filter with
neutral cleanser..
Note : Re-use of the the motor safety filter,
exhaust filter and washable filten
• Never wash the filter in a washing machine or in a
dishwasher.
• Never use hot water for washing the filter.
• Re-use the filter after drying it completely in the
shade.
• Do not dry near fire or direct sun ray,
3. Dust indicator
Dust indicator shows you red color when the dust
bin is full of dust..
Then, empty the dust bin and clean the washable
filter..
4. Avoid suction such materials as:
1) Liquid or wet dust: Clogging the ventilation holes,
reduces the intake power significantly and harms
the motor..
2) Inflammable liquids such as benzene, alcohol or
sol-vents.
3) Burning objects such as cigarette butts
4) Bulky objects such as vinyl, paper, etc.
5) Sharp objects such as needles, pins, metal or
glass particles, etc.
5. Attachments
• Nozzle : for cleaning wooden floor, the room floor
and carpet,.
, Crevice Tool: for cleaning any crevice, inside
corners of window flames,However,
do not use the crevice tool more
than 20 minutes because it may
cause harm to the motor..
- Dusting brush : for cleaning clothes curtains,,
6. Close supervision is necessary when this
vacuum cleaner is used by or near children,
Children's carelessness may cause damage to
the cleaner or injure persons.
7• Air exhausted from the vacuum cleaner is
normally warm. But if extraordinarily hot air is
exhausted, check if the extension wands, hose
or dust bin is fulled or not.
8. Electric shock could occur if used outdoors or
on wet surfaces•
2. CAUTIONS
BEFORE ATTEMPTING TO SERVICE OR ADJUST ANY PART OF THE VACUUM CLEANER, DISCONNECT
THE ELECTRICAL POWER SUPPLY CORD FROM THE WALL OUTLET.
1. Motor exchange
1) Separate the Body Cover and Body Base by
unfastening the screws.
2) Disconnect the lead wires.,
3) Lift the old motor and replace it with a new one°
2. In case of exchanging other parts, refer to the_ ........_,_.,,:.....
exploded view.
3. DESCRIPTION/SPECIFICATIONS
I ,, ii i1,1iii1,,,M'I'"' ,1"'
IMODEL 72! 26082B
3.2 MODEL 721.26082B
DESCRIPTION
AirFlow
TelescopicWa
/
Performance
Indicator
Latch
Hose
Cord Reel Button Power Switch
(ON/OFF)
Exhausl Cover
Power Cord
(Nol Shown)
Dusting Brush
UpholsteryNozzle AccessoryHolder CreviceTool
SPECIFICATIONS
t
POWER SOURCE : ON RATING PLATE
POWER CONTROL :
MAIN: ON/OFF
CAPACITY : 1.,5L
CORD LENGTH: 17ft
HOSE LENGTH : 6ft
- ATTACHMENTS
HOSE ASS'Y .............................................................................................! EA
TELESCOPIC WAND .......................................................................lEA
RUG/FLOOR NOZZLE ......................................................1EA
CREVICE TOOL (ON BOARD) ...............................................1EA
DUSTING BRUSH .......................................................................1EA
UPHOLSTERY NOZZLE ....................................... 1EA
NET WEIGHT: &5 lb
.... _ : /,_,,_t -¸-¸
PACKING WEIGHT: I3..5 Ib
NET DIMENSION : 10,,8x15o0x8,,7 (W x D x H) inch
PACKING DIMENSION : 13x19,5x11.4(WxDxH)inch
• This specifications are subject to change according to the buyer's request,,
4. DISASSEMBLY
..................................... i. .i..................._,
NOTE: Before attempting to service or adjust any part of the vacuum cleaner, disconnect the electrical power
supply cord from the wall outlet,
• Almost all of the parts of this vacuum cleaner can be
disassembled with a screw driver and each
connecting component easily fits each other.
Disassemble one by one referring to the exploded
view.,
• If possible, don't disassemble except for the
necessary parts. It is not necessary to disassemble
the parts that are not detailed in the exploded view
4.2 Dust Bin Replacement
t) Pull the dust bin up,
4.1 Filter Cover Assembly Replacement
1) Open filter cover by pushing cover latch_
Filter Cover
Latch
2) First, liftthe filter cover
- Push the hinge side by inserting flat screw driver
in gap between hinge and filter cover,.
Then the "filter cover" will be detached,.
2) Holdthe handle of the washable filter and pull itout of
the dust bin
Washable Filter
Catch
3) Pull the mesh screen down from
the washable filter,
Washable
Mesh
Loading...