Sears 486.245951 User Manual
Owner's Manual
®
STOP
DO NOT RETURN TO STORE
For Missing Parts or Assembly
Questions Call 1-866-576-8388
TOW BROADCAST SPREADER
Model No. 486.245951
CAUTION:
Before using this product, read
this manual and follow all Safety
Rules and Operating Instructions.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
www.sears.com/craftsman
PRINTED IN U.S.A.
• Safety
• Assembly
• Operation
• Maintenance
• Parts
FORM NO. 49914 (REV. 05/09/08)
TABLE OF CONTENTS
SAFETY RULES ..........................................................3
FULL SIZE HARDWARE CHART ................................ 4
CARTON CONTENTS .................................................5
ASSEMBLY .................................................................. 5
OPERATION ..............................................................10
MAINTENANCE/STORAGE ...................................... 12
SERVICE AND ADJUSTMENTS ............................... 13
TROUBLESHOOTING ...............................................13
REPAIR PARTS ILLUSTRATION .............................. 14
REPAIR PARTS LIST.................................................15
PARTS ORDERING/SERVICE .....................Back Page
WARRANTY
ONE YEAR FULL WARRANTY
When operated and maintained according to the instructions supplied with it, if this Spreader fails due to a defect in material
or workmanship within one year from the date of purchase, call 1-800-4-MY-HOME® to arrange for free repair (or replacement
if repair proves impossible).
If this product is used for commercial or rental purposes, this warranty applies for only 90 days from the date of purchase.
This warranty gives you specic legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., D817WA, Hoffman Estates, IL 60179
The model number and serial numbers will be found on
a decal attached to the tubular frame.
You should record both the serial number and the date of
purchase and keep in a safe place for future reference.
MODEL NUMBER: 486.245951
SERIAL NUMBER: __________________
DATE OF PURCHASE: __________________
2
SAFETY
Any power equipment can cause injury if operated improperly or if the user does not understand how to operate the equipment.
Exercise caution at all times, when using power equipment.
• Read the towing vehicle owners manual and towing
vehicle safety rules. Know how to operate your tractor
before using the broadcast spreader attachment.
• Read the chemical label instructions and cautions for
handling and applying the chemicals purchased for
spreading.
• Wear eye and hand protection when handling and
when applying lawn or garden chemicals.
• Never operate tractor and spreader attachment
without wearing substantial footwear, and do not allow
anyone to ride or sit on spreader attachment frame.
• Never allow children to operate the tractor or spreader
attachment, and do not allow adults to operate without
proper instructions.
• Always begin with the transmission in rst (low) gear
and with the engine at low speed, and gradually
increase speed as conditions permit.
• When towing broadcast spreader do not drive too
close to a creek or ditch and be alert for holes and
other hazards which could cause you to loose control
of the broadcast spreader and tractor.
• Before operating vehicle on any grade (hill) refer
to the safety rules in the vehicle owner's manual
concerning safe operation on slopes. Stay off steep
slopes!
• Follow maintenance and lubrication instructions as
outlined in this manual.
Look for this symbol to point out important safety precautions. It means — Attention!! Become
alert!! Your safety is involved.
3
HARDWARE PACKAGE CONTENTS
E
F
DCBA
J
K
L
G
H
I
M
N
O
P
Q
R
NOT SHOWN FULL SIZE
SHOWN FULL SIZE
U
T
V
S
KEY QTY. DESCRIPTION
A 4 Hex Bolt, 5/16" x 1-3/4"
B 6 Hex Bolt, 1/4" x 1-3/4"
C 2 Hex Bolt, 3/8" x 3/4"
D 2 Hex Bolt, 1/4" x 1"
E 1 Carriage Bolt, 1/4" x 3/4"
F 8 Nylock Hex Nut, 1/4"
G 4 Nylock Hex Nut, 5/16"
H 2 Nylock Hex Nut, 3/8"
I 4 Nylon Washer
J 7 Flat Washer, 5/16"
K 4 Flat Washers 3/4"
KEY QTY. DESCRIPTION
L 1 Cotter Pin, 3/32" x 3/4"
M 2 Cotter Pin, 1/8 x 1-1/2"
N 1 Hair Cotter Pin, 1/8"
O 1 Hitch Pin
P 2 Spacers
Q 1 Nylon Wing Nut
R 1 Adjustable Stop
S 1 Vinyl Cap
T 1 Grip
U 1 Flow Control Link
V 1 Drive Pin
4
CARTON CONTENTS
4
5
6
1
8
2
3
11
12
OFF
ON
1
2
3
4
6
7
8
9
10
5
7
9
10
1. Hopper Assembly
2. Braces (4)
3. Flow Control Rod
4. Flow Control Mounting Tube
5. Wheels (2)
6. Hitch Extension Bracket
7. Hitch Bracket
8. Hitch Tube
9. Flow Control Mount Bracket
10. Flow Control Arm
11. Hopper Cover
12. Screen
Hardware Package (see page 4)
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
ASSEMBLY
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify using
the illustrations on pages 4 and 5.
5
Loading...