Sears 42-34713, 42-34714, 42-34715 User Manual
iNSTALLATiON iNSTRUCTiONS
Stock No. 42=34713, 42=34714, 42=34715 Faucet
TO ASSEMBLE FAUCET:
1. If not already assembled, install the
escutcheon, rubber washer, spacer, flat washer
and hex nut onto the threaded faucet stud.
2. Turn the tubing adapter onto the stud and hand
tighten, then wrench 1/4 turn only. BE CAREFUL
NOT TO CROSS THREAD.
3. CONNECT TUBING TO FAUCET AS
FOLLOWS.
Note: For ease of tubing attachment, feed the
tubing through the mounting hole and attach to
faucet above the counter.
Insert
Spout __.._ _
Remove
Tubing Piece
Faucet &
Spout
T
Tubing Barb
Fittings
Escutcheon
a. Take the separate length of 3/8" black tubing
put an end through the hole in the rubber
washer. Slide the end onto the larger barb
fitting on the bottom of the faucet.
Note: To soften end of tubing, hold under hot
water.
b. Route 1/4" red tubing from RO up through the
sink hole and slide end onto the smaller barb
fitting (heat end if needed) on the faucet.
c. Route 3/8" blue tubing from RO up through
the sink hole and connect to the push-in tubing
adapter fitting on the bottom of the faucet. Be
sure it is held firmly in the adapter fitting. See
your owners manual for tubing connection
instructions.
4. Lower the faucet into the sink or countertop
hole.
5. On the underside of the sink or countertop,
insert the large steel washer between the
mounting hole and the spacer on the faucet stud
(see assembled view). Then, turn the hex nut up
to the spacer and tighten. Tighten the hex nut so
the faucet cannot move, but do not overtighten
and break the faucet.
6. Wet the o-ring seals on the faucet spout. Then,
remove and discard the short piece of tubing from
the faucet body and insert the spout in its place.
Plumber's
ASSEMBLED iN
MOUNTING HOLE
_'/Washer
Rubber
Washer
(_ _'_"_ Washer
Steel
Hex Nut
,, /-/ /l / /"_--Tubing from
3/8 Black Tubing..........-._/ / \\// Drain Point
to Drain Poinl/8, ' Blu/e_//_.I.!!NG FROM
Washer
Tubing RO SYSTEM
_'_-"---- Hex Nut
_ _ 1/4" Red
I.- Spacer
/ Adapter
Rubber
Steel
Flat
Tubing
Installation Questions? Call 1=800=426=9345
7254715 (Rev. B 9/19/07)
Loading...