Sears 134411800 User Manual

Meter Case Installation Hardware

Contents: Tools Required:

3/8 x 16 lock nut (1) 9/16 socket and drive

Installation Instructions:

1. Remove meter case access door.

2. InstaII 3/8 lock nut onto security bolt and tighten securely.

3. InstaII meter case access door.

INSTRUCTIONS TO CHANGE THE NUMBER OF COIN SLIDE INSERTIONS TO START APPLIANCE,

1. Disconrtect power from machine,

2. ]urn Shaft & Cam Assembly in a clockwise direction until switch lever arm drops into cam notch

3. Lift Adjusting Tab away from cam with finger and turn Tab to desired number. Make sure Tab\

4. ]urn Shaft & Cam Assembly in a clockwise direction until switch lever arm is on top of lab to

5. Reconnect power to machine,

-:--CAM NOTCH

\ _ TAB

\ \

(Fig. 2),

locks into place in new position,

assure that both mechanism switches are open (Fig, 3)

_ADJU ST:tENT

--DSE FINGER TO LIFT

TAB

__ SWITCH LEVER AP$1

FIGURE 2

I CLOCKWZSE

DIRECTION

FIGURE 3

P/N 134411800 (0403)