INSTRUCTIONS FOR:
FRONT AXLE UPPER BALL JOINT
EXTRACTOR/INSTALLER - VW T4
MODEL NO: VSE725.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction
manual
Wear eye
protection
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
Maintain the tool components in good and clean condition for best and safest performance.
Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
Keep children and other unauthorised persons away from the working area.
Ensure there is adequate lighting prior to using the ball joint replacement tool.
DO NOT use the kit if any parts are missing or damaged.
DO NOT use the ball joint replacement tool for any purpose other than that for which it is designed.
IMPORTANT: These instructions are intended as a guide only. Always refer to the vehicle manufacturer’s service instructions or a proprietary
manual to establish the current procedure.
2. INTRODUCTION
Suitable for removing and installing the upper front ball joint on-vehicle
without the need to disassemble. Features a variety of adaptors used in
different combinations for extracting and installing, see below. Supplied in
a carry-case with each part numbered for simple selection.
4. CONTENTS
3. APPLICATIONS
Model No:
Applications:......................VW: T4 2000cc, T4 2500cc
....................................VSE725.V2
5. OPERATION
© Jack Sealey Limited
Clean and lubricate the thrust screw with grease before use
Original Language Version
VS725.V2 Issue: 1 21/07/16
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
Environmental Protection
unserviceable and requires disposal of it according to local regulations.
NOTE: It is our policy to improve products continually and as such we reserve the right to alter data, specifications and component parts without
prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
VS725.V2 Issue: 1 21/07/16
Loading...