instructions for
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
TIE down - moTorcyclE rEAr whEEl
model no: Tdmcrw
Thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
refer to
instructions
1. SAfETy
9 When selecting web lashings (tie downs) consideration must be
given to the required lashing capacity, taking into account the
mode of use and the nature of the load to be secured.
9 tie downs must be strong enough and of the correct length for
the mode of use.
9 take care that the load is stable when the tie down is released.
9 Avoid exposure of the tie down to chemicals.
8 do noT use if tie down is damaged. A visual inspection before
use is recommended.
9 Avoid sharp edges. Protect tie downs by using sleeves or
corner protectors.
8 do noT overload.
8 do noT use if knotted.
2. InTroducTIon
manufactured from polyester webbing. Stitched reinforcement at joins and loops. Suitable for workshop use or for securing motorcycle to at-
bed or trailer. secures rear wheel to anchor point without compressing the suspension units, thus reducing the risk of seal damage. ratchet
mechanically tensions the webbing using a simple drum and ratchet mechanism for superior load restraint.
g.1
3. SpEcIfIcATIon
model no ................................................................tdmcrW
maximum tension ........................................................500Kg
load test ...................................................................1000Kg
Webbing Width .............................................................35mm
4. opErATIon
4.1. Position straps around rear wheel as shown in g 2.
4.2. Attach hook g 3. to anchor point so as to pull the bike forward.
4.3. using ratchet tighten strap until wheel is clamped into position.
g.2
g.3
© Jack sealey limited
Original Language Version
tDMCRW | Issue 1 02/01/18
5. STorAgE
5.1. Always store in a dry place.
6. mAInTEnAncE
6.1. use a light duty oil on the gears and slides to keep the ratchet operating properly.
EnvIronmEnT proTEcTIon
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey group, Kempson way, Suffolk Business park, Bury St Edmunds, Suffolk. Ip32 7Ar
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
© Jack sealey limited
Original Language Version
tDMCRW | Issue 1 02/01/18
Loading...