Sealey SDL11 User guide

Download

Page 1

30W LITHIUM-ION RECHARGEABLE

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

SOLDERING IRON KIT

MODEL NO: SDL11

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

Refer to

instructions

Wear eye protection

Warning:

Hot surfaces

Do not cover

Indooruse

only

1. SAFETY

 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this

 equipment,makesureyouknowwherethenearestreextinguisheris.

 WARNING!Alwayswearapprovedeye/faceprotectionwhenoperatingthesolderingiron.  WARNING!Donotusethesolderingironifyounoticedamagetotheworkpiece.  WARNING!Alwayspointthesolderingironawayfromtheeyesandbodywhenduringoperation.  WARNING!Donotputthesolderingirondown,putitbackinitsholder.  WARNING!Onlyuseinawellventilatedarea.

9  Keepammablematerialawayfromthetorchwhenoperating. 8 DO NOToperatethesolderingironwhenyouaretiredorundertheinuenceofalcohol,drugsorintoxicatingmedication. 8 DO NOTusethesolderingironinanareawherepaintfumes,solventsorotherammablesolids,liquidsorgasesposeapotential

 hazard.

8 DO NOTholdanyworkpiecebyhand. 8 DO NOTtouchtheworkpiececlosetotheheatedareaasitwillbeveryhot.Allowtocool. 8 DO NOToperatethesolderingironifitisdamagedasthismaycausefailureand/orpossiblepersonalinjury. 8 DO NOTtouchthetopofthesolderingironduringorimmediatelyafteruse,asitwillbeveryhot.Allowtocool. 8 DO NOTallowchildrentooperatethesolderingiron.

9  Whennotinuse,storeawayfromdirectsunlightinasafe,dry,childprooflocation. 8 DO NOTstoreatover40°C,suchasinacarinhotweather.

2. INTRODUCTION

 Cordlessandlightweightsolderingiron.InbuiltLEDtoilluminatesolderingareainlowlightareassuchasenginebays.Kitincludes  standard,chiselandheatshrinktipsaswellascleaningsponge,solder,standandUSBcharginglead.Heatsuptoamaximum   temperatureof600°Candhasa40minuteworkingtime.

3. SPECIFICATION

Model No.:.................................................................. SDL11

Battery:...................................................... 2.5AhLithium-ion

Charging time:................................................................3.5hr

MaximumTemperature:............................................... 6000C

OperatingTime:........................................................... 40min

Power Rating:.................................................................30W

Consumables:Seeg.1andtablebelow.

Item Description Part number

1 SolderingwireforSDL11 SDL11.SW

2 ChargingcordforSDL11 SDL11.CC

3 SolderingstandforSDL11 SDL11.S

4 30W Chisel tip SDL11.CHT

5 Cleaning sponge SDL11.CS

6 30W Cone tip SDL11.CT

7 30W Lighter and heat shrink tip SDL11.LHT

8 Interchangeabletips(setof3)NOTSHOWN SDL11.T

9 TransparentcapforSDL11NOTSHOWN SDL11TC

Original Language Version

g.1

SDL11Issue111/06/20

Page 2

4. OPERATION

4.1. CHANGING SOLDERING TIP

4.1.1. Ensure that the soldering iron tip is cold, select the appropriate tip and remove the current tip by applying a quarter turn to the tip  collar.Mounttherequiredtipbyliningupthelugs,slidingthecollardownthetoolandapplyingaquarterturn.

4.2. CHARGING

4.2.1. WhenconnectedtoaUSBpowersupplytheLEDinthehandlewillshowredwhilechargingandwillturngreenwhenfullycharged.

4.3. USING THE SOLDERING IRON

4.3.1. SlidetheHeatingandLEDcontrolslider(g.2)forwardtopreparethetoolforsoldering.

4.3.2. DepresstheredbuttonontopoftheslidecontroltoheatthetipandtoturnontheLED.Whiletheredbuttonisdepressedthetip  willcontinuetoheat.Ifthebuttonisreleasedthepowerise󰀨ectivelyswitchedo󰀨.

4.3.3. WhentheworkisdoneensurethattheHeatingandLEDcontrolsliderisreturnedtotheO󰀨position(g.2)andthatthetipiscold  beforestoringtheironbackinit’sbox.

g.2

5. MAINTENANCE

5.1. Ifsoiled,cleanthetoolusingusingaclean,dampcloth.DO NOTgetthetoolwet.

Partssupportisavailableforthisproduct.Pleaseemail[email protected]ortelephone01284757500

ENVIRONMENT PROTECTION

Recycleunwantedmaterialsinsteadofdisposingofthemaswaste.Alltools,accessoriesandpackagingshouldbesorted,takento arecyclingcentreanddisposedofinamannerwhichiscompatiblewiththeenvironment. Whentheproductbecomescompletely

unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids

accordingtolocalregulations.

WEEE REGULATIONS

Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment

(WEEE).Whentheproductisnolongerrequired,itmustbedisposedofinanenvironmentallyprotectiveway.Contactyourlocalsolid wasteauthorityforrecyclinginformation.

BATTERY REMOVAL

Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products

containingbatteries(asdefinedwithintheseregulations),thattheyareregisteredwithValpak’sregisteredcompliancescheme.Jack SealeyLtd’sBatteriesProducerRegistrationNumber(BPRN)isBPRN00705.

Note:Itisourpolicytocontinuallyimproveproductsandassuchwereservetherighttoalterdata,specificationsandcomponentpartswithoutprior notice.

Important:NoLiabilityisacceptedforincorrectuseofthisproduct. Warranty:Guaranteeis12monthsfrompurchasedate,proofofwhichisrequiredforanyclaim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

01284 757500 01284 703534 [email protected] www.sealey.co.uk

Original Language Version

SDL11Issue111/06/20