Sealey SA919 Instruction Booklet

Blow Gun

MPORTANT:

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

model no: SA919

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.

Refer to
instructions

Wear eye
protection

Wear protective

gloves

1. SAfeTy

 wARnInG! disconnect blow gun from the air supply before changing accessories, servicing or performing any maintenance. de-pressurise

the blow gun before removing air hose from the gun.

9 maintain the blow gun in good condition (use an authorised service agent).
9 Replace or repair damaged parts. Use genuine parts only. Non genuine parts may be
9 Keep the work area clean, uncluttered and ensure there is adequate lighting.
9 only use the blow gun for the purpose of blowing compressed air.

 wARnInG! Always wear approved eye or face protection when operating the blow gun. Use a

appropriate protective clothing.

9 maintain correct balance and footing. ensure the floor is not slippery and wear non slip shoes.
9 Remove ill fitting clothes, ties, watches, rings, other loose jewellery, and contain/tie back long hair.
9 Keep children and unauthorised persons away from the working area.
9 Secure non stable work piece with a clamp, vice or other adequate holding device.
9 Avoid unintentional starting.

 wARnInG! air pressure should not exceed 8bar.

9 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each

8 Do noT use the blow gun for any purpose other than for which it is designed.
8 Do noT operate blow gun if any parts are damaged or missing as may cause failure or personal injury.
8 Do noT carry the by the hose, or yank the hose from the air supply.
8 Do noT allow untrained persons to operate the blow gun.
8 Do noT operate blow gun when you are tired, under influence of alcohol, drugs or intoxicating medication.
8 Do noT leave the blow gun operating whilst unattended.
8 Do noT direct air from the blow gun at yourself, others or animals

9 When not in use disconnect from the blow supply and store in a safe, dry, child proof area.

dangerous and will invalidate the warranty.

face or dust mask if dust is generated. Wear

use, and ensure that all connections are secure.

2. InTRoDucTIon

die-cast metal body with moulded handle and hanging point. maximum operating pressure 110psi.

3. SpecIfIcATIon

model no: ....................................................................SA919

lance length: .............................................................200mm

Inlet size: ...................................................................1/4”BSP

4. opeRATIon

4.1. Connect to an air supply which has an 8 bar output.

4.2. Take the unpressurised air hose and connect it to the blow gun inlet.

4.3. Turn the air supply on, depress the gun trigger to release the flow of compressed air.

note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.

Important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.

envIRonMenT pRoTecTIon

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.

Sealey Group, Kempson way, Suffolk Business park, Bury St edmunds, Suffolk. Ip32 7AR

01284 757500 01284 703534 [e-mail] www.sealey.co.uk

© Jack Sealey limited

Original Language Version

SA919 | Issue 3 (HF) 26/03/18