INSTRUCTIoNS FoR:
MOTORCYCLE FORK SPRING
COMPRESSOR
MoDEL No: MS1824.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to the instruction
manual
Wear eye protection
Wear protective gloves
1. SAFETY
DO NOT use the spring compressor for a purpose it is not designed to perform.
DO NOT use the spring compressor if it is damaged.
DO NOT make any modifications to the spring compressor.
Maintain the spring compressor in a good clean condition for the best and safest performance.
When not in use, store in a dry location away from children.
2. INTRODUCTION
Designed to relieve fork spring tension allowing removal of the tube caps from the rod, without damaging
the threads. Can be used with the fork in situ or on the bench. Fits most modern road motorcycles.
Use with 17mm socket.
3. SPECIFICATION
Model No:................................. MS1824.V2
Maximum Reach:...................... 750mm
Maximum Fork Tube Diameter:. Ø32mm
4. OPERATION
Always refer to the original manufacturer's manual for assembly and dissassembly of motorcycle forks.
4.1. Clamp the fork spring compressor horizontally or vertically in a vice using the utility bracket.
4.2. Adjust the fork spring compressor length to suit the fork length approximately.
4.3. Remove the nut at the top of the fork.
4.4. Locate the bottom of the fork on the compressor pin.
4.5. The two screws on the tool are to align with the two holes in the fork internal sleeve. The fork internal sleeve is an aluminium alloy;
location of the screws and holes is required only. DO NOT apply force to the internal sleeve when locating.
4.6. Using a 17mm socket, tighten the tool pulling down the collar and the spring, which allows access to the nut holding the fork cap in
place.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Environmental Protection.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
MS1824.V2 Issue: 1 - 07/07/15
Loading...