Page 1
INSTRUCTIONS FOR
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
MOTORCYCLE HELMET & GEAR TIDY
MODEL NO: MS080.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
Refer to
instructions
1. SAFETY
8 DO NOT locate this tidy in such a position as to create the risk of injury from contact with the head or any other part of the body.
8 DO NOT overload this tidy; it should only be used for the designed purpose.
8 DO NOT locate in a position where items could fall from the tidy owing to accidental contact.
9 Ensure that the tidy is rmly xed to the wall using either the masonry xings supplied or alternative hollow wall xings (not supplied).
9 Ensure that, when installed, it can be accessed without over-reaching or over-balancing.
2. INTRODUCTION
Powder coated steel construction, for added corrosion resistance. Wall mounting unit designed to organise the storage of gloves, clothing and
helmet.
g.1
3. INSTALLATION & ASSEMBLY
3.1. Attach the wall plates to the two shelves using the four bolts provided. fig .2. Ensure the wall plates are perpendicular to the shelves.
3.2. Hold the assembled shelves in the desired position and mark the wall through the four holes. g.1
3.3. Remove from wall.
3.4. Use proprietory wall xings that are suitable for the type of wall and the weight of the loaded tidy. (not supplied)
3.5. Drill four holes suitable for the proprietory wall xings.
3.6. Fix the shelves to the wall.
© Jack Sealey Limited
Original Language Version
MS080.V2 | Issue 1 14/02/17
Page 2
g.2
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
Original Language Version
01284 757500
01284 703534
www.sealey.co.uk
MS080.V2 | Issue 1 14/02/17
Loading...