INSTRUCTIONS FOR
I
MPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
CORDLESS HEAD TORCH 3W CREE LED AUTO
SENSOR RECHARGEABLE
MODEL NO: HT106LED.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
Refer to
instruction
manual
1. SAFETY
1.1. GENERAL
9 Ensure the lamp is fully charged before initial use.
8 DO NOT turn the lamp on when it is being charged.
8 DO NOT shine directly into your, another person’s or an animal’s eyes.
8 DO NOT allow children to use the lamp.
8 DO NOT handle or move the lamp whilst it is being charged.
8 DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
8 DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
WARNING! To reduce the risk of burns or re:
8 DO NOT attempt to open, disassemble, modify or service the battery pack.
8 DO NOT crush, puncture, short external contacts or dispose of in re or water.
8 DO NOT expose to temperatures above 60°C (140°).
9 Replace only with the battery pack designated for this product.
9 Recycle or dispose of used battery as stipulated by local regulation.
9 If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.
Fig.1
2. INTRODUCTION
Hands-free 3W CREE XPE LED spotlight with adjustable inclination to direct light as required. Features auto sensor to switch on/off just by
waving hand in front. Alternatively can be overridden to stay on/off by push button. Adjustable headband and foam brow for added comfort.
Powered by rechargeable 3.7V 1.5Ah Li-Poly battery. Supplied with micro USB charging lead.
© Jack Sealey Limited
Original Language Version
HT106LED.V2 Issue: 3(SP) - 27/09/17
3. SPECIFICATION
Model No: ............................................................. HT106LED
Lumen Output: .............................................................180lm
Battery: .....................................................3.7V 1.5Ah Li-Poly
LED Qty: .........................................................3W CREE (x1)
Operating Time: .............................. 3hr @100%, 9hr @ 30%
Charging Time: ..................................................................4hr
4. OPERATION
4.1. Chargingrefertog.2
4.1.1. Connect the USB lead to the socket on the bottom of the battery, see g.2 and a USB power socket. Turn on the power supply. The
LED charging light on the bottom of the battery will light RED to show that charging has commenced.
4.1.2. When the battery is fully charged the LED will light GREEN.
4.2. Operation refertog.1
4.2.1. Press the on/off switch once for full light, twice for 30% light and three times for ashing light.
4.3. Auto-sensorrefertog.1
4.3.1. Press the auto-sensor button once to turn it on, the button will glow red.
4.3.2. Pass your hand in front of the sensor to turn the light on/off as required.
4.3.3. Turn the auto-sensor function off by pressing the auto-sensor switch once.
Fig.2
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
© Jack Sealey Limited
Original Language Version
HT106LED.V2 Issue: 3(SP) - 27/09/17
Loading...