Sealey GSS150815G Instructions Manual
INSTRUCTIONS FOR:
GALVANIZED STEEL SHED GREEN
1.5 x 0.8 x1.5m
MODEL NO: GSS150815G
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to
when building this shed.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
Keep children and unauthorised persons away from the working area.
DO NOT use the shed for any purpose other than that for which it is designed.
Use appropriate safety clothing including eye protection.
Note! The assembly of this product will require assistance.
2. INTRODUCTION
Galvanized, steel panels easily assembled to form a rigid and secure shed. Has a at roof and double doors. All other models have skillion (sloping)
roofs and single doors. Doors are secured by cross bolt and eyelet which will accept a padlock (not included) for additional security. All models are
supplied with bolt-down xing kits.
3. SPECIFICATION
Model No: ......................................................................GSS15081G
Overall Size (W x D x H*): .................................................. 1500 x 800 x 1500mm
Roof Type: .............................................................................Flat
*Minimum Wall Height
© Jack Sealey Limited
Original Language Version
GSS150815GG Issue: 1 - 01/09/14
4. CONCRETE PLINTH SLAB
Concrete Slab: It is recommended that your new shed is secured to a concrete slab as shown below.
Please ensure that your site is level. It is recommended that your slab is 100mm thick, you use a plastic
membrane and a suitable reinforcing mesh. We recommend that you make your slab 100mm bigger than the
base dimensions of your shed. This will allow for a 50mm edge around your shed. We recommend that you
slope the 50mm edges downward by 10mm so that rain water will drain away from your shed.
5. TOOLS REQUIRED
6. CONTENTS
Check contents: Lay out all components with the part numbers facing upwards and check off against the parts
lists on the next four pages. In the unlikely event of a missing component please contact you local Sealey dealer.
© Jack Sealey Limited
Original Language Version
GSS150815GG Issue: 1 - 01/09/14
sheet 1500 x 770
sheet 1500 x 735
sheet 1500 x 770
sheet 1500 x 770
sheet 855 x 770
sheet 855 x 735
sheet 1445 x 710
sheet 1445 x 710
© Jack Sealey Limited
Original Language Version
GSS150815G Issue: 1 - 01/09/14
© Jack Sealey Limited
Original Language Version
GSS150815G Issue: 1 - 01/09/14
© Jack Sealey Limited
Original Language Version
GSS150815G Issue: 1 - 01/09/14
7. PARTS DIAGRAM
© Jack Sealey Limited
Original Language Version
GSS150815G Issue: 1 - 01/09/14
Loading...