Sealey cx1042d Instruction Booklet

instructions for

MPORTANT:

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

trolley 2-level extra heavy-duty with
lockable top

model no: cx1042d

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.

refer to
instructions

1. Safety

1.1. GenerAl sAfetY
 WArninG! ensure Health & safety, local authority, and general workshop practice

regulations are adhered to when using this trolley.

9 Always load evenly with the centre of gravity of the load as near centre of the

trolley as possible.

8 do not overload the trolley - see section 2.

9 use the trolley in a suitable work area.
9 Keep the work area clean, uncluttered and ensure there is adequate lighting.

9 Keep the trolley clean and tidy in accordance with good workshop practice.
8 do not use the trolley for any purpose other than that for which it is designed.
8 do not stand on the trolley, use it as a ladder or allow others to ride on the trolley.

9 use the wheel locks to prevent the trolley from inadvertently moving.
8 do not leave unattended, especially when loaded, unless the wheels are locked,

chocked or the trolley otherwise secured.

8 do not use trolley on uneven ground and do not run over curbs or steps - use a

ramp.

8 do not use trolley if any part is significantly damaged, paying particular attention

to the wheels.

9 Keep children and unauthorised persons away from the work area.

note! opening heavily laden drawer may result in instability, particularly if shelves
are empty.

2. introduction

Garage or workshop trolley with a total capacity of 80kg. upper shelf has liner and lockable top, lower shelf may be installed base down or base
up to give either tool and component security or unobstructed access. two lockable drawers, with liners, give additional tool security. four large
castors, two braked.

3. contentS

carefully unpack the product and check the contents against the diagram and parts list below. should any items be missing or damaged contact
your sealey stockist.

4. aSSeMbly

4.1. mount tray (2) to the upper hole in the end frames (3) and loosely fix with four m6 x 32mm bolts (1). make sure the dished holes on the
end frames are facing outwards.

4.2. mount the drawer unit (7) and tray (11) to the middle and lower holes in the end frames (3) and loosely fix with m6 x 32mm bolts (1).

4.3. tighten all bolts (1).

4.4. turn the trolley over, install castors (4&5) into the bottom of the end frames and fix with the m6 x 12mm bolts (6)turn the trolley upright.
the trolley is ready to use.

© Jack sealey limited

Original Language Version

cX1042d | issue 3 10/01/17

5. partS

item part no: description

1 cX1042d.01 Bolt m6x32
2 cX1042d.02 trAY WitH lid
3 cX1042d.03 cHrome HAndle
4 cX1042d.04 cAster WHeel c/w BrAKe
5 cX1042d.05 cAster WHeel
6 cX1042d.06 Bolt m6x12
7 cX1042d.07 tool cHest
8 cX1042d.08 WAsHer m6
9 cX1042d.09 sPrinG WAsHer m6
10 cX1042d.10 nut m6
11 cX1042d.11 trAY

parts support is available for this product. to obtain a parts listing and/or diagram,

please log on to www.sealey.co.uk, email [e-mail] or telephone [phone].

environmental protection

recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.

iMportant: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.

© Jack sealey limited

sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar

Original Language Version

01284 757500
01284 703534

www.sealey.co.uk
[e-mail]

cX1042d | issue 3 10/01/17