InstructIon manual for:
aluminium scaffold ladder
model no:
thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: Please read THese insTrucTions carefullY. noTe THe safe oPeraTional reQuiremenTs, WarninGs & cauTions.
use THe ProducT correcTlY and WiTH care for THe PurPose for WHicH iT is inTended. failure To do so maY cause
damaGe or Personal inJurY and Will inValidaTe THe WarranTY. Please KeeP insTrucTions safe for fuTure use.
ascl2
1. safeTY insTrucTions
1.1 General safeTY
DANGER ! Take care when using and moving extended ladders in the vicinity of power cables - risk of potentially fatal electric shock.
WarninG! Ensure Health and safety, local authority, and general workshop practice regulations are adhered to when using this
equipment.
familiarise yourself with the application and limitations of the ladder, as well as the potential hazards.
maintain the equipment in good condition.
replace or repair damaged parts. use genuine parts only. unauthorised parts may be dangerous and will invalidate the warranty.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
WarninG! use ladder on level and solid ground and either have an assistant stand on the lowest rung or otherwise anchor the base of
the ladder to prevent slipping.
WarninG! do noT use the ladder, step ladder or scaffolding on sloping ground. When viewed from the front, the top of the ladder
section(s) must always be directly above the base.
Place ladder at an angle of 65° to 75
Where possible, lash top of ladder to a fixture to prevent slipping.
WarninG! never over-reach when on the ladder, step ladder or scaffolding.
Keep children and unauthorised persons away from the working area.
do noT use the ladder, step ladder or scaffolding for any purpose other than that for which they are designed.
do noT use the equipment if any parts are damaged or missing as this may cause failure and/or personal injury.
do noT exceed the rated capacity of the ladder, step ladder or scaffolding.
do noT climb scaffolding to get onto platform. always access the platform using a separate set of steps.
do noT allow children to climb the ladder, step ladder or scaffolding.
do noT use the equipment when you are tired or under the influence of alcohol, drugs or intoxicating medication.
°
- foot of ladder 1 metre from wall for each 3 metres up - for stability.
2. inTroducTion & sPecificaTion
2.1 introduction
En131 approved four-way scaffold ladder. two six-rung alumimium ladders can be used as
extending ladder, single ladders, step ladder or complete scaffolding unit. supplied with hand
rail.
2.2 specification
maximum load. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .150kg
Extension ladder maximum Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2700mm
closed length ........................................................1670mm
step ladder Height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1600mm
Platform length .......................................................1320mm
maximum Platform Height ................................................950mm
maximum Width (across feet). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .785mm
Weight ................................................................14.7kg
fig.2
fig.3
3. assemBlY & use
3.1 Work Platform
WarninG!
3.1.1 Bolt the foot cross members to the bottom of each ladder. the feet are already attached to the cross members. refer to fig.2.
3.1.2 attach the platform, at the desired height, to one ladder only.
note: ensure that the hole for the hand rail is nearest to the outer face of the ladder.
assembling the work platform is a two-man task.
Original Language Version
ascl2 Issue: 1 - 25/07/11
fig.1
3.1.3 Attachthesupportstaybetweentheplatformandtheladderbyinsertingitrstintotheplatform
and then attaching it to the ladder. refer to figs.2 and 3.
3.1.4 lift the platform assembly to the horizontal position and attach the second ladder, following the
procedure outlined in paragraph 3.1.3.
note: ensure that the hole for the hand rail is nearest to the outer face of the ladder.
WarninG! the platform height must not exceed 0.95 metres for reasons of stability.
note: The maximum loading of the platform when assembled is 150kg.
3.2 stairway work platform
WarninG! assembling the stairway work platform is a two-man task.
3.2.1 Bolt the foot cross members to the bottom of each ladder. the feet are already attached to the
cross members. refer to fig.2.
3.2.2 attach the stairway work platform, at the desired height, to the ground-based ladder.
3.2.3 attach the support stay between the stairway work platform and and the ground-based ladder
byinsertingitrstintotheplatformandthenattachingittotheladder.RefertoFigs.2and3.
3.2.4 lift the other end of the work platform to the horizontal position and attach it to the second
ladder, located on the upper step of the stairway.
3.2.5 attach the second support stay between the stairway ladder and the work platform. refer to
fig.3.
3.2.6 the maximum height above the ground of the steps on which the stairway ladder is to located
when assembled is 0.56 metres. refer to fig.3.
danGer! never attempt to climb the scaffolding to get onto the work platform. always
access the work platform using a separate set of steps.
note: The maximum loading of the stairway work platform when assembled is 150kg.
3.3 extension ladder
imPorTanT! always position the ladder at an angle between 65° and 75° to the
horizontal. The ladder will be within this range if the base is one third of the effective
ladder length away from the foot of the wall. refer to fig.4.
3.3.1 assemble the extension ladder with the two lower rungs of the extension section set in the
retaining hooks of the top part of the ground based section. refer to fig.5.
3.3.2 the maximum height of the extension ladder is 2.7 metres (minimum overlap of two rungs).
fig.4
fig.5
3.4 step ladder
3.4.1 assemble the step ladder by connecting the top rung of one ladder to the retaining hooks
located on the top rung of the other ladder. refer to fig.6.
3.4.2 connect the support stays to each side of both ladders.
3.4.3 the height of the step ladder when assembled is 1.6 metres.
fig.6
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
imPorTanT: no liability is accepted for incorrect use of this product.
WarranTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
informaTion: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
sole uK distributor, sealey Group,
Kempson Way, suffolk Business Park,
Bury st. Edmunds, suffolk,
IP32 7ar
Original Language Version
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
ascl2 Issue: 1 - 25/07/11
Loading...