Sealey AP2020BB Instructions Manual

INSTRUCTIONS FOR:

HEAVY-DUTY WORKBENCH WITH 2 DRAWERS
BALL

BEARING RUNNERS

MODEL

No’s

:

AP2020BB

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.

1. SAFETY INSTRUCTIONS

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

2. CONTENTS AND SPECIFICATION

1.1 GENERAL SAFETY

! WARNING! Ensure Health & Safety, local authority, and general workshop practice

regulations are adhered to when using this bench.

" Locate bench in a suitable working area.
" Keep the work area clean, uncluttered and ensure there is adequate lighting.
! WARNING! Use bench on level and solid ground, preferably concrete. Avoid tarmacadam

since the bench may sink into the surface.

" Keep the bench clean and tidy in accordance with good workshop practice.
" Keep children and unauthorised persons away from the working area.
# DO NOT use the bench for any purpose other than that for which it is designed.
# DO NOT exceed maximum capacity of workbench.
# DO NOT undertake work on the bench without the workpiece being adequately secured. Use

clamps or a vice (not included) to secure the workpiece. Available from your Sealey dealer.

# DO NOT use the bench out of doors.
# DO NOT get the bench wet or use in damp or wet locations or areas where there is

condensation.

# DO NOT clean the bench with any solvents which may damage the paint surface or the

protective coating on the wooden top.

! Maximum weight for each drawer is 25kg, full load for workbench is 250kg.

AP2020BB - 1 - 260407

2.1 Powder coated steel panels with 40mm wood laminate top. Two drawers, open storage space for larger items. Supplied flat packed.

2.2

Table Size (W x D): 1372 x 508mm
Working Height: 865mm
Capacity: 250kg

2.3 Carefully unpack the product and check the contents against the diagram below. Should any items be missing or damaged make

immediate contact with your Sealey dealer.

A . . . .SIDE PANEL G . . . .LEFT SIDE PANEL M . . . . .DRAWER R . . . . .RIGHT SlDE RUNNER

C . . . .BOTTOM RAIL H . . . .RIGHT SIDE PANEL O . . . . .CORNER BRACE S . . . . .SCREW (M5x12)

D . . . .TOP RAIL J . . . . .BACK PANEL P . . . . .WOODEN TOP T . . . . .ADJUSTABLE LEG LEVELLER

E . . . .CENTRE SUPPORT K . . . .SHELF Q. . . . .LEFT SIDE RUNNER U . . . . .HEX HEAD SCREW 5/8"

3. ASSEMBLY

STEP 2. Attach the outer slide to the corresponding left/right slide panel (G, H). Insert the tabs into the holes in the slide panel making sure that

the slider stop fits into the small hole.

AP2020BB - 1 - 260407

1

2

Ball bearing runner disassembly: Press the plastic lock spring up or down, and pull the inner
slide out. To put the runners back on, slot the inner slide into the middle slide and push all the
way in.

Step 1. As shown in the diagram attach the two large side panels (A), bottom rail (C) and centre support (E) together.