Sealey AK422 Instruction Booklet

INSTRUCTIONS FOR:
BATTERY TERMINAL CRIMPING TOOL
Model No: AK422
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health and Safety, local authority and general
workshop practice regulations are adhered to when using tools.
 DO NOT use tools if damaged.  Wear approved eye protection. A full range of personal safety
equipment is available from your Sealey dealer.
 Wear suitable clothing to avoid snagging. Do not wear jewellery
and tie back long hair.  Maintain tool in good and clean condition for best and safest performance. When not in use, clean and lubricate tool, and store in a safe,
dry, childproof location.
IMPORTANT: This manual is provided as a guide only, refer
to the vehicle manufacturer’s service instructions, or a
proprietary manual, to establish the current procedure and data.
 WARNING! Failure to heed safety and warning instructions may
result in damage and/or personal injury and will invalidate the warranty.
 WARNING! The warnings, cautions and instructions
refer r e d to in this manual cannot cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are factors
which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
A quick and effective way of crimping battery terminals using either a hammer or vice. Wide throat and spring controlled punch securely holds terminal in place for added security. Compatable with battery terminals with a cross sectional area of 6, 10, 16, 25, 35 and 50mm².
3. OPERATION
3.1. Select the appropriate sized terminal to t the cable being
worked on. Strip off cable insulation to a length approximately 3mm longer than the length of the terminal barrel.
3.2. Insert stripped cable fully into battery terminal (or connector). Lift ram of tool and place terminal on anvil so bottom of ram rests
on the middle of terminal barrel.
3.3. Strike ram with a hammer (or put tool in a vice and tighten) until
the line on the ram corresponds to the cable size used and is even with the top of the tool.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product. WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
©Jack Sealey Ltd Original Language Version
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park, Bury St. Edmunds, Suffolk, IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
AK422 Issue: 1 - 26/09/13
Loading...