Seagate PERSONAL STORAGE 3000LE User Manual

Personal Storage 3000LE Installation Guide for Macintosh
Personal Storage 3000LE
Installation Software for Macintosh and Windows
©
2
0
0
1
M
a
x
t
o
r
C
o
r
p
o
r
a
t i
o
n
.
A
l
l
R
i
g
h
t
s
R
e
s
e
r
v
e
d
.
Pre
1
Thank You
Thank you for selecting the Maxtor Personal Storage 3000LE. Please follow these installation instructions to reap the full benefits of your purchase.
USB Backward Compatibility
The Maxtor Personal Storage 3000LE is backward compatible and can be used with current computer systems with built-in USB 1.1 ports. If your computer does not have USB 2.0 support built in, a USB 2.0 PCI adapter card is required to achieve USB 2.0 data transfer rates.
Handling Precautions
If these handling precautions are not followed, dam­age to the 3000LE may result and your warranty may become void. Please see the Warranty section for additional information.
• DO NOT bump, jar or drop this device as it may
• DO NOT stack device more than three units high.
• DO NOT set the device on its side as it may fall
Installation
cause loss of data.
over and damage the internal hard drive.
Hardware
3
Personal Storage Installation
To connect your new Maxtor Personal Storage 3000LE to your computer, please follow these simple steps. If these steps are not performed in order, the 3000LE may not function properly.
1. Ensure that your computer is turned on and is
2. Plug the four-pin male connector with the flat side
Installation
running one of the required operating systems.
facing up into the back of the 3000LE’s DC power-in connector (Figure 1).
Figure 1
Power Connection
Macintosh
4
1. Please close all open programs before you begin
2. Insert the Maxtor CD into your CD-ROM drive.
3. Double-click on the Maxtor Software Installer
4. In the Save dialog box, click “Save” to create a
5. Click Restart.
You are now ready to use your new Maxtor Personal Storage 3000LE.
For your convenience, Maxtor has formatted the 3000LE with one large PC-DOS file structure. To change the file structure, please follow these steps:
1. Go to the folder where you have saved the Maxtor
Software Setup
the software installation.
icon. The license agreement screen will display. Click “I Agree.”
folder on your desktop called “Maxtor USB Device.”
Utilities files and double-click on the “Maxtor Utilities” icon. You will see the setup utility:
• DO NOT remove any cables or power without properly disconnecting the device via your operat­ing system – as this may cause data loss and pos­sible damage to the internal hard drive.
• DO NOT set any liquids or drinks on the device. Liquids will damage the internal electronics.
• DO NOT attempt to open the device. It will void the warranty.
• NOT intended as a portable device.
Hardware and Operating System Requirements for Macintosh
• PowerPC with on-board USB port (iMac, G3 or higher)
• Mac OS 9.0 or higher
• 32MB of RAM
• Internet connection
Kit
2
Components
3. Connect the female end of the power cord into the power adapter (Figure 2).
Figure 2
Power Adapter
Connection
2. With the Maxtor USB Device highlighted, click on the “Setup” button. You will then receive a data protection warning. If you don’t have data that you want to keep, click on “OK.”
3. Select the Volume format you want to use.
The Maxtor Personal Storage 3000LE comes complete with the components shown here. Please familiarize yourself with each of these items prior to installation.
Personal Storage 3000LE
Power Adapter
USB Interface Cable
4. Plug the male connector from the power adapter into your power source.
USB Data Cable Connections
1. Plug the larger end of the USB cable into any available USB port on your computer.
2. Plug the smaller end of the USB cable into the USB connection on the 3000LE (Figure 3).
When the initialization has completed, the Maxtor Utility screen will reappear. You are now ready to use your new Maxtor Personal Storage 3000LE with your desired file system.
Disconnecting the 3000LE
While in the Finder, drag the drive icon to the Tra sh. Then you may disconnect your 3000LE.
Reattaching the 3000LE
To re-attach the 3000LE, simply re-insert the USB cable into the 3000LE and your computer. Make sure
the 3000LE is getting power.
Please see the reverse side of this poster for Product Registration and Warranty information.
CD-ROM
Figure 3
USB Interface Cable
Hook-up
Changes are periodically made to the information herein – which will be incorporated in revised editions of the publication. Maxtor may make changes or improvements in the product(s) described in this publication at any time and without notice. This product tested to comply with FCC standards for home or office use.
©
Copyright U.S.A. 9/01. Maxtor Other brands or products are trademarks or registered trademarks of their respective holders.
2001 Maxtor Corporation. All rights reserved. Printed in the
®
is a registered trademark of Maxtor Corporation.
www.maxtor.com p/n: 20163100, rev. A/Mac
Personal Storage 3000LE Installation Guide for Windows
Personal Storage 3000LE
Installation Software for Macintosh and Windows
©
2
0
0
1
M
a
x
t
o
r
C
o
r
p
o
r
a
t i
o
n
.
A
l
l
R
i
g
h
t
s
R
e
s
e
r
v
e
d
.
Pre
1
Thank You
Thank you for selecting the Maxtor Personal Storage 3000LE. Please follow these installation instructions to reap the full benefits of your purchase.
USB Backward Compatibility
The Maxtor Personal Storage 3000LE is backward compatible and can be used with current computer systems with built-in USB 1.1 ports. If your computer does not have USB 2.0 support built in, a USB 2.0 PCI adapter card is required to achieve USB 2.0 data transfer rates.
Handling Precautions
If these handling precautions are not followed, dam­age to the 3000LE may result and your warranty may become void. Please see the Warranty section for additional information.
• DO NOT bump, jar or drop this device as it may
• DO NOT stack device more than three units high.
• DO NOT set the device on its side as it may fall
• DO NOT remove any cables or power without
• DO NOT set any liquids or drinks on the device.
• DO NOT attempt to open the device. It will void
• NOT intended as a portable device.
Hardware and Operating System Requirements for Windows PC
• Pentium II-class equivalent processor or higher
• 32MB of RAM
• Available USB 1.1* or USB 2.0 port
• Internet connection
Installation
cause loss of data.
over and damage the internal hard drive.
properly disconnecting the device via your operat­ing system – as this may cause data loss and pos­sible damage to the internal hard drive.
Liquids will damage the internal electronics.
the warranty.
Hardware
3
Personal Storage Installation
To connect your new Maxtor Personal Storage 3000LE to your computer, please follow these simple steps. If these steps are not performed in order, the 3000LE may not function properly.
1. Ensure that your computer is turned on and is
2. Plug the four-pin male connector with the flat side
3. Connect the female end of the power cord into
Installation
running one of the required operating systems.
facing up into the back of the 3000LE’s DC power-in connector (Figure 1).
Figure 1
Power Connection
the power adapter (Figure 2).
Figure 2
Power Adapter
Connection
Windows PC
4
Windows Millennium/2000/XP
Maxtor has completely setup your new Personal Storage 3000LE with one large FAT32 partition.
1. Start your computer.
2. Plug the larger end of the USB cable into any
3. Windows will detect the "USB Mass Storage
4. Restart your system.
You are now ready to use your new Maxtor Personal Storage 3000LE.
Windows 98SE
Additional drivers are required to use the Maxtor Personal Storage 3000LE with Windows 98SE. Please follow these steps for proper installation.
1. Without attaching the 3000LE, start your
2. Insert the Maxtor CD into your CD-ROM drive.
3. Follow the on-screen prompts.
4. Once the installer is finished, restart your computer.
5. Plug the larger end of the USB cable into any USB
6. Windows will detect "USB Mass Storage Device."
You are now ready to use your new Maxtor Personal Storage 3000LE.
Disconnecting the 3000LE
Right click on the Windows Unplug or Eject Hardware icon in your system icon tray located at
the bottom right corner of your screen.
Reattaching the 3000LE
1. Plug the male connector from the power cord into
2. Plug in the smaller end of the USB cable into the
Software Setup
USB port on your computer.
Device" and install the drivers for it.
computer.
port on your computer.
your electrical wall outlet.
USB connection on the 3000LE.
• CD-ROM drive
• Windows 98 Second Edition, Windows Millennium, Windows 2000 or Windows XP
* Upgrade to USB 2.0 with a Maxtor USB 2.0
Adapter Card (optional)
Kit
2
The Maxtor Personal Storage 3000LE comes complete with the components shown here. Please familiarize yourself with each of these items prior to installation.
Components
Personal Storage 3000LE
Power Adapter
USB Interface Cable
CD-ROM
4. Plug the male connector from the power adapter into your power source.
USB Data Cable Connections
1. Plug the larger end of the USB cable into any available USB port on your computer.
2. Plug the smaller end of the USB cable into the USB connection on the 3000LE (Figure 3).
Figure 3
USB Interface Cable
Hook-up
www.maxtor.com p/n: 20163100, rev. A/PC
Product
5
Take advantage of the benefits!
By registering your new 3000LE, you’ll have the option to receive product updates, special offers, and important information about other data storage solutions from Maxtor.
Simply point your web browser to: www.maxtor.com – go to the product registration page, and complete the short questionnaire.
Registration
Product Warranty
Maxtor’s warranty obligations are limited to the terms set forth: Maxtor warrants only to the original consumer purchaser that new Maxtor products will be free from defects in material and workmanship for 1 year from the date of original purchase.
For a replacement product, the warranty on the replacement device is the remain­der of the warranty on the original device or 90 days, whichever is longer. If you discover a defect, Maxtor will, at its option, repair or replace the product at no charge to you, provided you return it during the warranty period, with transporta­tion charges prepaid, to Maxtor in Ireland, Singapore or the USA.
Products must be properly packaged in Maxtor packaging or Maxtor approved packaging to obtain warranty service. Before returning a Maxtor product, please contact Maxtor at: +353 1 204 1111 (in Europe) or 1-800-2MAXTOR (in U.S.) to obtain a Return Material Authorization (RMA) number. A copy of the receipt or a bill of sale bearing the appropriate Maxtor serial number and model number may be required for warranty service. The warranty applies only to the Maxtor products that can be identified by the Maxtor trademark, trade name, serial number or logo affixed to them. Maxtor does not warrant any product that is not manufactured by, for or with permission from Maxtor.
This warranty is not applicable to: Abnormal wear and tear; Abuse, unreasonable use, mistreatment, or neglect; Damage caused during installation of the Product; Damage caused by the equipment or system with which the product is used; Damage caused by modification or repair not made or authorized by Maxtor; Product whose Maxtor Serial Number has been removed or defaced; Damage caused by liquids in the product case; Damage to the products’ interface or power connectors; Damage caused by use of non-Maxtor packaging; Damage caused by improper or improperly used packaging; Products that are determined to be stolen.
THIS WARRANTY AND REMEDIES SET FORTH ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL OTHERS, WHETHER ORAL OR WRITTEN, EXPRESSED OR IMPLIED. MAXTOR SPECIFICALLY DISCLAIMS ANY AND ALL IMPLIED WAR­RANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF MER­CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE AND AGAINST INFRINGEMENT. ADDITIONALLY, MAXTOR DOES NOT WARRANT THAT THE INSTALLATION SOFTWARE FOR WINDOWS OS WILL MEET YOUR REQUIRE­MENTS NOR THE PERFORMANCE OR RESULTS THAT THE OPERATION OF THE PROGRAM WILL BE UNINTERRUPTED OR ERROR FREE. NO MAXTOR DEAL­ER, AGENT OR EMPLOYEE IS AUTHORIZED TO MAKE ANY MODIFICATION, EXTENSION OR ADDITION TO THIS WARRANTY.
MAXTOR IS NOT RESPONSIBLE FOR SPECIAL, INCIDENTAL, INDIRECT OR CON­SEQUENTIAL DAMAGES RESULTING FROM ANY BREACH OF WARRANTY, OR UNDER ANY OTHER LEGAL THEORY, INCLUDING BUT NOT LIMITED TO LOSS OF DATA, LOSS OF PROFITS, DOWNTIME, GOODWILL, DAMAGE OR REPLACE­MENT OF EQUIPMENT AND PROPERTY, AND ANY COSTS OF RECOVERING, PROGRAMMING OR REPRODUCING ANY PROGRAM OR DATA STORED IN OR USED WITH MAXTOR DISK DRIVES OR MAXTOR PRODUCTS CONTAINING MAX­TOR DISK DRIVES OR ANY SOFTWARE PRODUCT DISTRIBUTED THEREWITH.
Some states/jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or exclusions of implied warranties, so the above limita­tions or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from jurisdiction to jurisdiction.
Loading...