Seagate FIREBALL ST User Manual

Fireball ST

Jumper Settings

ATA

Jumper Settings

S tand Alone ON

M aster with Slave Present ON

S lave to Master OFF

X = PK is a Parking position. The presence or absence of this jumper has no effect on the drive.

Labeling may indicate to place this jumper when configuring as a slave. This is to provide for retention of the jumper in the event it is needed later.

Jumper Locations The Fireball ST disk drive has only one location where user configurable jumpers are found. The jumper block is incorporated into the IDE / ATA cable connector. Using the jumper pins you can establish the drive Master/Slave configuration.

OFF

Rsvd

OFF

1 of 1

Fireball ST

fireball_st_jumper.pdf

BIOS Settings The following BIOS parameters are provided for customers needing to manually configure the Quantum disk drive. Both base 2 and base 10 capacity values are displayed.

1 .6 GB 3128

2 .1 GB 4092

3 .2 GB 6256

4 .3 GB 14848

6 .4 GB 13328

Special Considerations Hard drives greater than 2.1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions

4.0 through 6.22 allow a maximum primary partition / logical drive size of 2.1GB and are limited to 8.4GB in physical drive capacity. The file systems supported by Windows-95, Windows-98 and Windows NT are not restricted to the 8.4GB physical drive limit, but special BIOS support is required.

Cylinders

Heads

SCSI

Jumper Settings

The following describes the jumper options and settings available on the Fireball ST drive. For more detail on jumper definitions; please refer to the jumper definition

Termination Enable (TE)

E nable termination T E jumper on

D isable termination T E jumper off

SCSI ID (A2, A1, A0)

S et drive SCSI ID S ee ID settings table below

Park (PK)

U sed for spare jumper N /A

Jumper Locations The Fireball ST disk drive has one location where user configurable jumpers are found. The jumper block for the Fireball ST is found on the disk drive printed circuit board. Using these jumper pins you can establish the various drive configuration options.

Sectors

section.

Base 2 Capacity Base 10 Capacity

1,539 MB

2,014 MB

3,079 MB

4,110 MB

6,149 MB

1,614 MB

2,111 MB

3,228 MB

4,310 MB

6,448 MB

2 of 2

+ 1 hidden pages