Page 1
Manual SRM Series
Manual Pull-Down Projection Screen
USER’S GUIDE
Page 2
Pre-installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
INSTALLATION
Flush Wall Mounting
1. Mark the location of where the screen is to be installed for the pre-drilled hole.
2. After marking the area and drilling the hole, insert the proper screw into the drilled hole and leave
about 1/8” of an inch from the wall to mount the screen.
3. Mount your screen from the keyhole located on back of screen’s left and right end cap.
Ceiling Mounting
(additional hardware required)
Optional installation using a chain to hang the screen from the ceiling.
1. You can also hang the screen on a ceiling by using a chain (not included) and hang it by the two loops
located on each end of the case.
SCREEN OPERATION
Back of end cap
Front view
Page 3
Note: Always pull the screen down or let it up in a 90-degree vertical angle. Do not allow the screen to touch
the screen case when the screen goes up or comes down to avoid damaging the screen material.
1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull
the screen down by the surface or touch the screen, as it will damage the screen and void the warranty.
Note: An internal auto-lock mechanism system will cause the screen to stop and lock on the position at
intervals.
2. If you want to the screen to retract back, simply pull the screen down more than 2 inches and retract the
screen back by quickly and smoothly releasing it up gently.
The screen is equipped with a SLOW RETRACT
MECHANISM (SRM) which allows the screen to slowly retract without the need to hold on to the handle or
lanyard. Simply release the handle and the screen will retract by itself.
Note: Always release at a 90-degree angle and do not let go until the screen is entirely inside the case
If ever the screen feels stuck, keep in mind that the screen’s mechanism is new and needs to be run up/down
a few times to loosen up. If this happens, carefully with a little force yank the screen straight down to unlock
the screen.
Note: Improperly bringing the screen up/down will damage the screen material or rolling system.
MAINTENANCE
Clean matte white screen material with a soft cloth and mild soap with water.
When not in use, retract screen in its housing to keep the screen material surface clean.
Page 4
NOTE:
Regardless of mounting method, the screen should be securely supported so that vibration or even abusive
pulling on the viewing surface will not cause the case to work loose or fall. The installer must insure that the
fasteners used are of adequate strength and suitable for the mounting surface chosen.
Manual SRM Series Dimensions Table
Unit: mm
Models
Diagonal
Size/Aspect
Ratio
Case
Length
(A)
Screen
Width
(A1)
View
Width
(A2)
Weight
Bar
Length
(A3)
Bottom
Edge
Distance
(B4)
Screen
Material to
Weight Bar
Height (B3)
View
Height
(B1)
Overall
Height
(B)
End
cap
Height
(B5)
End
cap
Width
(C)
Screen
material
distance
to wall
(C1)
N.W.
(KGS)
M85XWS1-SRM 85" (1:1) 1677 1603 1527 1673 62 1703 1527 1795 92 79.5 20 6.0
M99NWS1-SRM 99" (1:1) 1938 1854 1778 1934 62 1954 1778 2046 92 79.5 20 8.0
M113NWS1-SRM 113" (1:1) 2192 2106 2030 2188 62 2206 2030 2298 92 79.5 20 9.2
M84NWV-SRM 84" (4:3) 1867 1783 1707 1863 62 1456 1280 1548 92 79.5 20 6.2
M100NWV1-SRM 100" (4:3) 2192 2108 2032 2188 62 1700 1524 1792 92 79.5 20 8.0
M120XWV2-SRM 120" (4:3) 2598 2514 2438 2594 62 2005 1829 2097 92 79.5 20 10.4
Unit: inch.
Models
Diagonal
Size/Aspect
Ratio
Case
Length
(A)
Screen
Width
(A1)
View
Width
(A2)
Weight
Bar
Length
(A3)
Bottom
Edge
Distance
(B4)
Screen
Material to
Weight Bar
Height (B3)
View
Height
(B1)
Overall
Height
(B)
End
cap
Height
(B5)
End
cap
Width
(C)
Screen
material
distance
to wall
(C1)
N.W.
(LBS)
M85XWS1-SRM 85" (1:1) 66.0 63.1 60.1 65.9 2.4 67.0 60.1 70.7 3.6 3.1 0.8 13.2
M99NWS1-SRM 99" (1:1) 76.3 73.0 70.0 76.1 2.4 76.9 70.0 80.6 3.6 3.1 0.8 17.6
M113NWS1-SRM 113" (1:1) 86.3 82.9 79.9 86.1 2.4 86.9 79.9 90.5 3.6 3.1 0.8 20.2
M84NWV-SRM 84" (4:3) 73.5 70.2 67.2 73.3 2.4 57.3 50.4 60.9 3.6 3.1 0.8 13.6
M100NWV1-SRM 100" (4:3) 86.3 83.0 80.0 86.1 2.4 66.9 60.0 70.6 3.6 3.1 0.8 17.6
M120XWV2-SRM 120" (4:3) 102.3 99.0 96.0 102.1 2.4 78.9 72.0 82.6 3.6 3.1 0.8 22.9
*Measurement dimensions are intended as a reference only and subject to change without notice.
Note: Data Error ±1"
Loading...