SDI Technologies IDM12 User Manual

iDM12 IB Front 324Wmm x 155Hmm Print in Black color Oct. 25,10

Maintenance

• Place the unit on a level surface away from sources of direct sunlight or excessive heat.

• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other

protective material should be placed between it and the furniture.

• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such

as Benzene, thinner or similar materials can damage the surface of the unit.

A Consumer Guide to Product Safety

When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit.

1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.

2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings.

3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.

4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.

5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket.

6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions.

7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product.

8. Attachments – Do not use attachments not recommended by the product manufacturer.

9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges.

10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.

11. Damage Requiring Service – The unit should be serviced by qualified service personnel when:

A. the power supply cable or plug has been damaged. B. objects have fallen into or liquid has been spilled into the enclosure. C. the unit has been exposed to rain. D. the unit has been dropped or the enclosure damaged. E. the unit exhibits a marked change in performance or does not operate normally.

12. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a month or longer, the power cable should be unplugged from the unit to prevent damage or corrosion.

13. Servicing – The user should not attempt to service the unit beyond those methods described in the user’s operating instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel.

Questions? Visit www.ihomeaudio.com

or call 1-800-288-2792 Toll Free

Limited 90-Day Warranty Information

iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase.

Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI Technologies will repair or, at its discretion, replace this product without charge (except for a $10.00 charge for handling, packing, return UPS/postage, and insurance). This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed below. The product must include proof of purchase, including date of purchase. The fee for service without proof of purchase is $20.00.

Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or defective batteries are the most common cause of problems encountered.

If service is still required:

1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.

2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the warranty period.

3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($20.00 without proof of purchase).

4. Send the unit prepaid and insured, to the Factory Service Center listed below.

Consumer Repair Department

SDI Technologies Inc. 1330 Goodyear Drive

El Paso, TX 79936-6420

Disclaimer of Warranty

NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner.

This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser. In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI Technologies product.

Questions? Visit www.ihomeaudio.com

or call 1-800-288-2792 Toll Free

Printed in ChinaiDM12-102510-A

Model iDM12

portable rechargeable

Bluetooth stereo speaker

pairing

Visit www.ihomeaudio.com

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This Device complies with RSS-210 of the IC Rules; Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This device must accept any interference received, including

interference that may cause undesired operation

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential area.

However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate interference you can try one or more of the following corrective measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and the radio or TV.

• Use outlets on different electrical circuits for the equipment and the radio or TV.

• Consult your dealer or an experienced radio/television technician if the problem still exists.

Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the system’s warranty and void your FCC authorization to operate it.

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

IMPORTANT

Read before proceeding

If you have any question reagarding the operation or use of this product, please vist www.ihomeaudio.com to view answers to frequently asked questions.

To learn more about this and other iHome products, please visit us online at www.ihomeaudio.com

For Models That Use Lithium Batteries:

• Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high temperatures &

not handled appropriately

• Do not place loose batteries in a pocket, purse, or other container containing metal objects, do not mix with used or other battery

types, or store with hazardous or combustible materials.

• Store in cool, dry, ventilated area.

• Follow applicable laws and regulations for transport and disposal.

Questions?

FCC ID:EMOIDM12 IC:986B-IDM12

this is 8pt text statmenet

2.2mm height

iDM12 IB inside 324Wmm x 155Hmm Print in Black color Oct 25,2010

Step 1:Set up

a) Grip the top and gently pull

away to separate it from the main speaker unit. Pull out the folding stand on the back of the speaker unit to keep it upright.

b) To use the top as an iPad

stand, fold out the feet.

c) Place stand on a flat, stable

surface. Dock iPad into groove. For best stability,dock iPad in landscape mode.

Step 3:Using Bluetooth:

Pairing Your Device

a) Turn on Bluetooth capability on your

device and make it discoverable (see your device’s instructions).

b) Press and hold the Play/Pause/Pairing

Button on the iDM12 until an amber light flashes on front of the unit.

c) Once paired with a device, the amber

light will glow steadily. There should be an indication on your device that pairing is complete. Once paired, your device should link to the iDM12 whenever it comes into range. See Step 4 to Play Bluetooth audio.

pairing

Turn Unit On and Off

speaker stand

Bluetooth / Aux select switch Mini USB charging port

Mini USB to USB / 3.5mm Audio cable

TOP/FRONT VIEW

Power Button

Bluetooth mode (amber)

Fold out

Volume Down

Button

pairing

Battery charge (green) /

indicator LED

BACK VIEW

Volume Up

Button

Play/Pause/Pairing

Press and hold to begin

Bluetooth pairing

Button

Step 2:Charging the Unit

a) Connect the mini USB plug to the mini USB

charging port on the back of the unit.

b) Connect the standard USB plug end of the cable

to a power USB port on a computer or other

device.

c) A green light flashes while unit is

charging and glows steadily when unit is fully charged.

NOTE:

When unit is not connected to power source, flashing green light indicates battery needs charging.

USB 2.0

Step 4:Playing Audio

VIA BLUETOOTH

a) Move the Bluetooth/Aux switch to the

Bluetooth position to listen to audio streamed wirelessly from your iPad, iPhone, iPod or other Bluetooth device.

b) Use Volume +/- Buttons to adjust

volume.

VIA AUX

a) Connect the mini USB plug to the mini

USB charging port on the back of the

unit and connect the 3.5 mm audio plug to the headphone or line-out jack on your device.

b) Move the Bluetooth/Aux switch to the

Aux position to listen to audio.

c) Use Volume +/- Buttons to adjust

volume.

Rechargeable Lithium-ion Battery

This device uses an internal rechargeable Lithium-ion battery that should last the lifetime of

the device. If you suspect your battery may be dead, try charging it several times. If the battery

does not recharge, please contact us for repair information. Please do NOT attempt to change the battery yourself. If the battery has died and you do not want Manufacturer to replace your

battery, you should follow the disposal instructions below.

WARNING/DISPOSAL OF UNIT

Manufacturer to replace your battery, you should follow the disposal instructions below. not want Manufacturer to replace your battery, you should follow the disposal instructions below:

• Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances.

• Always dispose of used batteries/electronics in accordance with the prevailing community regulations that apply to the disposal of batteries/electronics. If there are no local regulations concerning battery/electronics disposal, please dispose of the device in a waste bin for

electronic devices.

• Many electronics retailers now recycle batteries and other electronic components at no charge. Check to see which ones in your area do so.

Using The iDM12

Not sure we need this section, may need more complete description of pairing and linking

Bluetooth devices.