SDI Technologies IBT39N User Manual

iBT39 QSG (EN) size: 110 x 165 (mm) color: 2C + 1C (PMS7467C + black) Material: 350gsm2 art card Nov 3, 2016

PMS7467C

Model: iBT39

QUICK START GUIDE

In the Box

Charging

» Connect the micro-USB plug on the

included charging cable to the USB Charging jack on the speaker.

» Connect the larger USB plug to a

powered USB port such as that on a computer or a USB AC adaptor.

Battery Level Meter on front of unit

Bluetooth Pairing & Playing

» Make your device “discoverable” by turning on Bluetooth mode » Press and release the Power Button to turn on iBT39

» The ﬁrst time the unit is

powered on it will enter auto-pairing mode

» Select “iHome iBT39” on your device’s Bluetooth menu to complete pairing » Press the Play/Pause Button to play/pause music » Press the

Speakerphone

» The speaker must be on and connected with a paired Bluetooth device to recieve calls » Press the FWD/Answer Call Button to answer call » For call waiting function, use phone controls on your device » Press the REV/End Call Button again to end call

Waterproof Operation

» For waterproof operation, ensure the

waterproof cover on side of unit is pressed completely ﬂush with the unit

» iBT39 speaker » charging cable

Battery Charge Status

dead, needs charge

low, needs charge

46 - 60% charged

60 - 99% charged

100% charged

Pairing the First Time

or + buttons to adjust volume

Computer connected to working outlet

USB AC adaptor (not included)

» After powering unit on

Press and hold the

Bluetooth Pairing Button for 2 seconds

water

tight

For warranty information and full instruction book visit: www.ihome.com/support

Computer USB port

Manual Pairing

not water tight

iHome iBT39

USB port

iBT39

FCC Information

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• Warning: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-3 (B)/NMB-3(B)

Canada Statement

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.

Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf.

iBT39 - 161103 -A(EN) Printed in China

FCC ID:EMOIBT39N

IC:986B-IBT39N