SDI Technologies HBH34 User Manual

HBH34 Quick Start Guide - Front Size: 432 x 140 mm Printing Color: Black Mat’l: 100 gsm WF paper Nov 11, 2016

FCC ID: EMOHBH34

IC: 986B-HBH34

HBH34

Staff Quick Start Guide

Included

• HBH34 system

• Security tether

Set Up

Remove thumbscrew

and remove back cover to access staff controls.

Secure the attached Security Tether to a wall

or other permanent surface. CAUTION: DO NOT attach to an AC outlet or cause it to become entangled with anything that can create a hazardous situation.

outlet

Connect AC plug

to a working outlet that is not controlled by an On/Off switch.

Security tether

Set the Volume Limiter Switch on the back of the unit (Off for large rooms, On for smaller rooms).

o on

volume limit

Setting the Time Zone and Clock

(Factory Preset Clock)

The first time you connect your new preset clock to the AC outlet, the unit will automatically show the correct Eastern Standard time, which is the default setting. If you are not in the Eastern time zone, you must change the default setting to match your time zone (see Time Zone Setting below). Once the correct time zone is set, if the time displayed is not correct, follow steps under Manual Clock Setting to set the correct time, year and date.

Time Zone Setting

Make sure unit is in Power OFF mode.

Press and hold the Time Zone Button on the back of the unit for 2 seconds. The time zone will flash.

time zone

2 SECS

Press the – or + Button to cycle to local time zone.

Press Time Zone Button again to confirm.

Daylight Saving Time

The unit ships with the Daylight Saving Time (DST) switch in Auto position, and will automatically adjust when the time changes in March and November. If Daylight Saving Time is NOT observed in your location, move the DST switch from AUTO to -1 or +1 BEFORE setting time.

dst

+1 -1 auto

Bluetooth Pairing

1. Press and hold the Bluetooth Button. Unit will enter pairing mode.

2. Select “HBH34” on your device’s Bluetooth menu.

HBH34 Quick Start Guide - Inside Size: 432 x 140 mm Printing Color: Black Mat’l: 100 gsm WF paper

Manual Clock Setting

Press and hold the Time Set Button for 2 seconds to enter clock setting mode.

time set

2 SECS

Press the - or + button to set the time.

Press the Time Set Button to confirm the time. The year will flash.

Press the - or + button to set the year.

time set

Press the Time Set Button to confirm the year. The date will flash.

time set

Press the - or + button to set the date. Hold for rapid adjustment.

Press the Time Set Button to confirm the date and exit clock setting.

time set

√

Backup Batteries

Keep unit connected to AC power when replacing batteries or you will lose settings.

Remove pull tab from Backup Battery Compartment located on bottom of theunit.

When Low Battery Icon appears on display, replace backup batteries with 2 fresh AA batteries. Make sure polarity (+/–) markings match illustration.

Once staff has completed setup, replace security cover on back of unit and tighten thumbscrew.

Reset Button

The courtesy plug on top of the unit is rated for 15 amps. If a guest connects a device that overloads the outlet, the built in circuit breaker will prevent damage to the unit. The Reset Button on the back of the unit will pop out to indicate the outlet was overloaded. Press and release the Reset Button to reset the circuit breaker and restore the courtesy plug to operation.

reset

Maintenance

• Place the unit on a level surface away from sources of direct sunlight or excessive heat.

• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should be placed between it and the furniture.

• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as thinner or similar materials can damage the surface of the unit.

+ 1 hidden pages